Bedienungsanleitung Kenwood KRC-794 (Seite 38 von 44) (Englisch)

35976

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

English

— 38 —— 38 —

? The Mask Key item isn’t displayed in the Menu System.33

✔ The Mask Key function is already activated.

☞ When the Mask Key function is activated it isn’t displayed in the

menu items.

? The Touch Sensor Tone doesn’t sound.34

✔ The preout jack is being used.

☞ The Touch Sensor Tone can’t be output from the preout jack.

? Even though Synchronize Clock is ON, the clock can’t be adjusted.35

✔ The received RDS station isn’t sending time data.

☞ Receive another RDS station.

? Even though the vehicle light switch is turned ON, the unit’s display

won’t dim.36

✔ The dimmer wire isn’t connected.

☞ Connect the dimmer wire correctly.

? The Dimmer function doesn’t work. 38-1

✔ The Dimmer wire isn’t connected correctly.

☞ Check the Dimmer wire connection.

? The display color changes subtly. 38-2

✔ This is because thetemperature is different than the temperature

when the setting was done.

☞ The display color condition changes subtly according.to the

ambient temperature.

Tuner source

? Radio reception is poor.39

✔ The car antenna is not extended.

☞ Pull the antenna out all the way.

✔ The antenna control wire is not connected.40

☞ Connect the wire correctly, referring to the section on

<Connecting Wires to Terminals>.

? The desired frequency can’t be entered with the Direct Access

Tuning.41

✔ A station that can’t be received is being entered.

☞ Enter a station that can be received.

✔ You’re trying to enter a frequency with a 0.01 MHz unit.42

☞ What can be designated in the FM band is to 0.1 MHz.

? It isn't the set Traffic information sound volume. 43

✔ The set sound volume is less than the tuner sound volume.

☞ If the tuner sound volume is louder than the set sound volume,the

tuner sound volume is used.

Cassette tape source

? Can’t remove tape.44

✔ The cause is that more than 10 minutes has elapsed since the vehicle

ACC switch was turned OFF.

☞ The tape can only be removed within 10 minutes of the ACC

switch being turned OFF. If more than 10 minutes has elapsed,

turn the ACC switch ON again and press the Eject button.

? The DPSS, Tape Advance and Music Repeat don’t operate

correctly.45

✔ The space between the songs on the tape can’t be recognized

because it’s too short.

☞ Have at least 4 seconds between songs.

✔ The space between songs can’t be recognized because there’s too

much noise between songs.46

☞ Reduce the noise between songs.

? The blank skip doesn’t work.47

✔ Because noise is too loud, the non-recorded part can’t be recognized.

☞ Reduce the noise between songs.

? Blank Skip functions at places that are recorded.48

✔ Because the recording level is low, it’s recognized as not recorded.

☞ Turn Blank Skip OFF.

Disc source

? "AUX" is displayed without achieving External disc control mode.50

✔ O-N switch is set to "O" side.

☞ Set the switch to "N" side.

✔ Unsupported disc changer is connected.51

☞ Connect the supported disc changer. (page 3)

Troubleshooting Guide

KRC-794_U.S 03.1.17 3:34 PM Page 38

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kenwood KRC-794 Seite 38

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Kenwood KRC-794

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info