To assemble
The splashguard assembly consists of 2
pieces: the head shield
br
and the
splashguard
bs
.
The splashguard cannot be fitted to the
bowl unless the shield is fitted.
1 Raise the mixer head until it locks.
2 Clip the head shield upwards onto the
underside of the mixer head
8
until fully
located.
3 Fit the bowl onto the base.
4 Lower the mixer head.
5 Rest the splashguard on the bowl rim
and then slide forward until fully located
9
.
• During mixing, ingredients can be added
directly to the bowl via the feed chute.
6 To remove the splashguard simply slide it
away from the mixer bowl.
7 To remove the head shield, raise the
mixer head until it locks. Remove the tool
if fitted, then pull the head shield
downwards from the underside of the
mixer head.
Note: Only fit or remove the splashguard
when the mixer head is in the locked
position.
We recommend that the head shield
is removed regularly from the mixer
head for cleaning.
K-beater & Whisk
The tools are set to the correct height for
the bowl supplied in the factory and should
not require adjustment.
However, if you wish to adjust the tool use
a suitable sized spanner:
TYPE KVC50 = 17mm
TYPE KVL60 = 19mm
Then follow the instructions below:
1 Unplug the appliance.
2 Raise the mixer head and insert the
whisk or beater.
3 Lower the mixer head. If the clearance
needs to be adjusted, raise the mixer
head and remove the tool. Ideally the
whisk and K-beater should be almost
touching the bottom of the bowl
bk
.
4 Using a suitable spanner loosen the nut
sufficiently to allow adjustment of the
shaft
bl
. To lower the tool closer to the
bottom of the bowl, turn the shaft anti-
clockwise. To raise the tool away from
the bottom of the bowl turn the shaft
clockwise.
5 Re-tighten the nut.
6 Fit the tool to the mixer and lower the
mixer head. (Check its position see
points above).
7 Repeat the above steps as necessary
until the tool is set correctly. Once this is
achieved tighten the nut securely.
• Note: Spanner
bl
shown is for
illustration purpose only.
Dough Hook
This tool is set at the factory and should
require no adjustment.
8
To fit and use your
Splashguard
Tool Adjustment
5720000183 Iss 1 KVC50_KVL60 multi_5720000173 Iss 1 KVC50_KVL60 Eng_Arabic 20/05/2014 08:06 Page 8
