Bedienungsanleitung Kenwood NXR-5800 (Seite 1 von 16) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Türkisch)

683152

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

UNPACKING AND CHECKING EQUIPMENT

Note: The following unpacking information is for use by your

KENWOOD dealer, an authorized KENWOOD service center, or the

factory.

Carefully unpack the repeater. We recommend that you identify

the items listed in the following table before discarding the

packing material. If any items are missing or have been damaged

during shipment, ﬁ le a claim with the carrier immediately.

Item Part Number Quantity

Front glass B10-2781-XX 1

Dressed screw N08-0563-XX 1

Bracket J29-0725-XX 2

Flat head machine screw N32-4008-XX 4

Handle K01-0421-XX 1

DC cord E30-3427-XX 1

Lead wire with connector (15 pin) E31-3228-XX 1

Fuse (15 A) F52-0042-XX 1

SYNC cable E3A-0177-XX 1

Instruction manual B5A-0714-XX 1

INSTALLATION

To install the handles onto the front panel of the repeater, align

the handles with the holes on the front panel, then secure the

handles using the supplied screws.

Consult your dealer for installing the repeater and antenna.

MICROPHONE

Connect an optional KMC-30, KMC-35, KMC-9C, or KMC-53

KENWOOD microphone to the MICROPHONE jack on the front

panel.

OCXO UNIT (KXK-3): Option

The OCXO unit (KXK-3) is an Oven Controlled Crystal Oscillator

(OCXO) unit.

NOTICES TO THE USER

◆

Government law prohibits the operation of unlicensed radio

transmitters within the territories under government control.

◆

Illegal operation is punishable by ﬁ ne and/or imprisonment.

◆

Refer service to qualiﬁ ed technicians only.

◆

This repeater is intended for use as a ﬁ xed base station with

the antenna located outdoors on the rooftop or on an antenna

tower.

◆

This repeater is designed for a 13.2 V DC power source.

Never use a 24 V DC or higher source to power the repeater.

◆

Use only the supplied DC cord.

◆

Do not remove the ferrite core attached to the DC cord. Doing

so may cause interference with radio communications.

◆

Do not put anything on top of the repeater. This will obstruct

heat dissipation.

THANK YOU!

We are grateful you purchased this KENWOOD repeater.

PRECAUTIONS

• Do not expose the unit to rain or moisture; to prevent ﬁ re or

electric shock.

• Do not open the unit under any circumstances; to avoid risk

of electric shock.

• Do not expose the unit to long periods of direct sunlight, nor

place it close to heating appliances.

• Do not place the unit in excessively dusty and/or humid

areas, nor on unstable surfaces.

• Do not put the plastic bag used for packing of this equipment

on the place which reaches a small child's hand. It will

become a cause of suffocation if it wears ﬂ atly.

• Always switch the transceiver power off before installing

optional accessories.

• If you detect an abnormal odor or smoke coming from the

unit, disconnect the power from the unit immediately. Contact

your KENWOOD service center or dealer.

NOTIFICATION

This equipment complies with the essential requirements of Directive

1999/5/EC.

The use of the warning symbol means the equipment is subject to

restrictions of use in certain countries.

This equipment requires a licence and is intended for use in the countries

as below.

AT BE DK FI FR DE GR IS IE

IT LI LU NL NO PT ES SE CH

GB CY CZ EE HU LV LT MT PL

SK SI BG RO HR TR

ISO3166

B5A-0714-00 (E)

VHF DIGITAL BASE-REPEATER/ UHF DIGITAL BASE-REPEATER

INSTRUCTION MANUAL

NXR-5700/ NXR-5800

◆

Do not install the repeater in explosive atmospheres

(inﬂ ammable gas, dust particles, metallic powders, grain

powders, etc.).

Hereby, JVCKENWOOD Nederland B.V. declares that the radio

equipment types in this instruction manual are in compliance with

Directive 1999/5/EC. The full text of the EU declaration of conformity

is available at the following internet address:

http://www.kenwood.com/cs/com/ecdoc/

(Note: The detail type designations are described in the EU

declaration of conformity.)

Firmware Copyrights

The title to and ownership of copyrights for ﬁ rmware embedded in

KENWOOD product memories are reserved for JVC KENWOOD

Corporation.

Information on Disposal of Old Electrical and Electronic Equipment and Batteries

(applicable for countries that have adopted separate waste collection systems)

Products and batteries with the symbol (crossed-out wheeled bin)

cannot be disposed as household waste.

Old electrical and electronic equipment and batteries should be

recycled at a facility capable of handling these items and their waste

byproducts.

Contact your local authority for details in locating a recycle facility

nearest to you.

Proper recycling and waste disposal will help conserve resources

whilst preventing detrimental effects on our health and the environment.

2015

The AMBE+2

voice coding Technology embodied in this product

is protected by intellectual property rights including patent rights,

copyrights and trade secrets of Digital Voice Systems, Inc. This

voice coding Technology is licensed solely for use within this

Communications Equipment. The user of this Technology is

explicitly prohibited from attempting to extract, remove, decompile,

reverse engineer, or disassemble the Object Code, or in any other

way convert the Object Code into a human-readable form. U.S.

Patent Nos. #6,199,037, #6,912,495, #8,200,497, #7,970,606, and

#8,359,197.

Kenwood NXR-5800 Anleitung

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info