before using your Kenwood
appliance
●
Read these instructions carefully and
retain for future reference.
●
Remove all packaging and any
labels.
safety
general
●
Never touch the mixing shaft whilst
the appliance is plugged in.
●
Keep fingers, hair, clothing and
utensils away from moving parts.
●
Always unplug:
●●
before fitting or removing parts
●●
after use.
●●
before cleaning
●
Never mix hot ingredients.
●
Never use a damaged appliance.
Get it checked or repaired: see
‘service’.
●
Never put the appliance in water or
let the cord or plug get wet - you
could get an electric shock.
●
Never let the cord touch hot
surfaces or hang down where a
child could grab it.
●
Never add ingredients to the beaker
whilst the appliance is operating.
●
Only use the appliance with the
beaker supplied.
●
Make sure the beaker is located
correctly before switching on the
appliance.
●
Do not let infirm people use the
appliance without supervision.
●
Do not let children use or play with
the appliance.
●
Only use the appliance for its intended
domestic use. Kenwood will not accept
any liability if the appliance is subject to
improper use, or failure to comply with
these instructions.
before plugging in
●
Make sure your electricity supply is
the same as the one shown on the
power handle.
●
This machine complies with
European Economic Community
Directive 89/336/EEC.
before using for the first time
1Wash the parts: see ‘cleaning’.
key
ቢ control switch
ባ beaker support/interlock
ቤ mixing shaft
ብ beaker rest
ቦ beaker
ቧ maximum level
ቨ minimum level
ቩ tilting head
to use your drinks
maker
1Make sure the control switch is off
(O) and then plug into the power
supply.
2 Place the ingredients into the beaker.
●
The beaker must always be filled to
at least the minimum level mark or
the liquid will not reach the mixing
shaft. Do not fill above the
maximum level mark or liquid may
overflow while mixing.
3 Place the beaker onto the drinks
maker, making certain that the
beaker’s top edge is behind the
beaker support/interlock and its
bottom edge is on the beaker rest.
●
Failure to locate the beaker into the
beaker support/interlock will prevent
the appliance from operating.
●
To assist with the fitting or removal
of the beaker the drinks maker head
can be tilted upwards
ᕡ. Never tilt
the head during the mixing
operation.
4 Move the control switch to the
desired speed. Start mixing on
speed 1 then increase to speed 2 if
required.
●
Most drinks should be mixed in less
than 2 minutes.
5 When mixing is complete, switch off
the drinks maker, remove the beaker
and pour out the drink.
English
2
