Bedienungsanleitung Kenwood TS-870S (Seite 2 von 104) (Englisch)

606693

Zoom out

Zoom in

Vorherige Seite

1/104

Nächste Seite

WRITING CONVENTIONS FOLLOWED

The writing conventions described below have been

followed to simplify instructions and avoid unnecessary

repetition. This format is less confusing for the reader.

Reviewing the following information now will reduce

your learning period. That means less time will be

spent reading this manual; more time will be available

for operating.

Furthermore, a system of advisories is used as follows:

CAUTION:

Possibility of equipment damage

Note:

Important information or operating tip

Note:

Basic procedures are numbered sequentially to guide you

step-by-step. Additional information pertaining to a step, but not

essential to complete the procedure, is provided in bulleted form

following many steps for further guidance.

NOTICE TO THE USER

One or more of the following statements may be

applicable to this equipment.

INFORMATION TO THE DIGITAL DEVICE USER REQUIRED

BY THE FCC

This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential

installation.

This equipment generates, uses and can generate radio

frequency energy and, if not installed and used in accordance

with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that the

interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference

by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and

receiver.

• Connect the equipment to an outlet on a circuit different from

that to which the receiver is connected.

• Consult the dealer for technical assistance.

FCC WARNING

This equipment generates or uses radio frequency energy.

Changes or modifications to this equipment may cause harmful

interference unless the modifications are expressly approved in

the instruction manual. The user could lose the authority to

operate this equipment if an unauthorized change or modification

is made.

APPLICABLE MODEL

This manual applies to the following model:

TS-870S: HF Transceiver

Intelligent Digital Enhanced Communications System

Instruction What to do

Press and release KEY.

Press and hold KEY1 down,

then press KEY2. If there are

more than two keys, press and

hold down each key in turn

until the final key has been

pressed.

Press KEY1 momentarily,

release KEY1, then press

KEY2.

With the transceiver power

OFF, press and hold KEY,

then switch ON the transceiver

power by pressing

[ ] (POWER).

Press [KEY].

Press

[KEY1]+[KEY2].

Press

[KEY1], [KEY2].

Press

[KEY]+[ ].

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kenwood TS-870S Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Kenwood TS-870S

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info