683161

Kenwood TS-890S Seite 191

191
Zoom out
Zoom in
Vorherige Seite
1/196
Nächste Seite
Warning Messages
The following warning messages are displayed in the event of an erroneous operation or when a problem on this transceiver is detected.
Follow the steps described for each warning message to resolve the problem. If “Troubleshooting” is indicated in the warning message
or when the problem cannot be resolved, please refer to the list of error messages and “Troubleshooting” (18-2).
ID Message Description/Corrective Action
000C This audio file cannot be reproduced. (WR: 000C)
Appears when the format of the wav file is not supported by this
transceiver.
Check the file format on a PC to see if the file is in the wav format that
can be played on this transceiver.
0031
Due to insufficient memory of the data storage or the write
protection of the USB flash drive, the data storing process was
terminated. (WR: 0031)
Ensure that there is sufficient memory and that data storage has
been enabled.
Appears when the maximum number of files in each folder has been
exceeded, insufficient memory space or writing forbidden is detected
when writing a file.
0032 Selects the days of the week. (WR: 0032)
Appears when [OK] is pressed with all the days of the week unchecked
on the program timer configuration screen.
0033
A maximum of 4 hours of recording time can be configured. (WR:
0033)
Ensure that the Power-on Time and Power-off time are
appropriate.
Appears when [OK] is pressed with the time limit exceeded when
configuring the Power-on Time and Power-off Time on the program timer
configuration screen.
0034
The same clock time cannot be configured for both the Power-on
Time and Power-off Time. (WR: 0034)
Ensure that the Power-on Time and Power-off Time are
appropriate.
Appears when [OK] is pressed with an invalid time range configured for
this transceiver on the program timer configuration screen.
0039
Failure in formatting of a USB flash drive has been detected. (WR:
0039)
The failure may be caused by one or more of the following:
•
The write protected USB flash drive is connected to a USB
connector.
•
The USB flash drive is not correctly connected to a USB
connector.
•
The security-protected USB flash drive is connected to a USB
connector.
Appears when formatting of the USB flash drive failed.
Follow the instructions in the message.
0043 The file cannot be accessed while recording data. (WR: 0043)
Appears when attempting to read a log file for which recording is
currently in progress.
004A Select copy item. (WR: 004A)
Appears when attempting to copy files to a PC with all the files
unchecked on the screen for selecting the files to copy.
0053 Select delete item. (WR: 0053)
Appears when attempting to delete files while all the files are unchecked
on the screen for selecting the files to delete.
0101
The Programmable Timer is about to start recording the received
audio. (WR: 0101)
The recording can begin if the transceiver has been turned OFF.
If the USB flash drive has selected as the file storage location,
connect a USB flash drive to the USB connector before recording
starts.
Appears when the power of this transceiver is turned on approximately
3 minutes and 1 minute before timer recording starts. Follow the
instructions in the message.
0102
Recording by the Programmable Timer.(WR: 0102)
To stop recording, press and hold [(BREAK)] (F).
Appears when [ ] is pressed and held down during timer recording
while the screen is turned off.
0104
High temperature has been detected in the transmitter. Refer to
"Troubleshooting" in the instruction manual (WR: 0104).
To prevent the transmitter from being damaged, the transmit
power has been reduced to 5 W.
Stop the transmission and allow the temperature of this transceiver to
go down.
0106
Very high temperature has been detected in the transceiver. Refer
to "Troubleshooting" in the instruction manual (WR: 0106).
Transmission capability is disabled until the transceiver cools
down.
Is the ambient temperature of this transceiver high (such as when the
transceiver is exposed to direct sunlight)? Please operate it in a well-
ventilated place.
TROUBLESHOOTING 18
18-11
… 191 …

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Kenwood TS-890S wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Kenwood TS-890S

Kenwood TS-890S Bedienungsanleitung - Deutsch - 196 seiten

Kenwood TS-890S Bedienungsanleitung - Holländisch - 196 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info