Bedienungsanleitung Kenwood VR-705 (Seite 8 von 32) (Englisch)

596379

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

Setting up the system

Make connections as shown in the following pages.

When connecting the related system components, be

sure to refer to the instruction manuals supplied with

the components you are connecting.

Do not connect the power cord to a wall outlet until all

connections are completed.

Notes

1. Be sure to insert all connection cords securely. If their connections are

imperfect, the sound may not be produced or there will be noise

interference.

2. Be sure to remove the power cord from the AC outlet before plugging

or unplugging any connection cords. Plugging/unplugging connection

cords without disconnecting the power cord can cause malfunctions

and may damage the unit.

3. Do not connect power cords from components whose power

consumption is larger than what is indicated on the AC outlet at the

rear of this unit.

Analog connections

Audio connections are made using RCA pin cords. These cables transfer

stereo audio signal in an “analog” form. This means the audio signal

corresponds to the actual audio of two channels. These cables usually

have 2 plugs at each end, red for the right channel and white for the left

channel. These cables are usually packed together with the source unit,

or are available at your local electronics retailer.

Microcomputer malfunction

If operation is not possible or an erroneous display appears, even

though all connections have been made properly, reset the

microcomputer by referring to “In case of difficulty”. º

Input mode settings

CD/DVD, VIDEO2 and DVD or DVD/6CH (VR-715/KRF-V5070D

only) inputs each include jacks for digital audio input and analog audio

input.

After completing connections and turning on the receiver, follow the

steps below.

1 Use the INPUT SELECTOR knob to select CD/DVD, VIDEO2,

DVD or DVD/6CH (VR-715/KRF-V5070D only).

2 Press the INPUT MODE key.

Each press switches the setting as follows:

In DTS play mode

1 F-AUTO (digital input, analog input)

2 D-MANUAL (digital input)

In CD/DVD, VIDEO2, DVD or DVD/6CH (VR-715/KRF-V5070D

only) play mode

1 F-AUTO (digital input, analog input)

2 D-MANUAL (digital input)

3 6CH INPT (DVD/6CH input)

4 ANALOG (analog input)

Digital input:

Select this setting to play digital signals from a DVD, CD, or LD

player.

Analog input:

Select this setting to play analog signals from a cassette deck, VCR,

or record player.

Auto detect:

In “F-AUTO” (full auto) mode (AUTO DETECT and DIGITAL

indicators light up), the receiver detects the digital or analog input

signals automatically. Priority is given to digital signal during input

mode selection. The receiver will select the input mode and listening

mode automatically during playback to match the type of input

signal (Dolby Digital, PCM, DTS ) and the speaker setting. The initial

factory setting is full auto.

To keep the receiver set to the currently selected listening mode,

use the INPUT MODE key to select “D-MANUAL” (digital manual).

However, even when this setting is selected, there may be cases

in which the listening mode is selected automatically to match a

Dolby Digital source signal depending on the combination of listening

mode and source digital.

In D-MANUAL mode, if the audio reproduction stops in the middle

due to change in the input signals, etc, press the LISTEN MODE

key.

If the INPUT MODE key is pressed quickly, sound may not be

produced. Press the INPUT MODE key again.

INPUT MODE

INPUT SELECTOR

LISTEN MODE

*5337/08-15/EN 27/12/02, 1:05 PM8

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kenwood VR-705 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info