XD SERIES (En/E2)
7
Preparation section Basic section Application section Knowledge sections
−
+
44
÷When connecting the parallel cord, insert plug straight into the
connector until it clicks to look them securely.
÷ When connecting the parallel cord, the wire while line should come
to the left side end.
÷ When disconnecting the parallel cord, push in the two sides of the
plug and pull it straight out.
1. Be sure to insert all connection
cords securely. If their connec-
tions are imperfect, the sound
may not be produced or noise
may interfere.
2. Before plugging or unplugging
a connection cord, be sure to
unplug the power cord from
the wall AC outlet. If connec-
tion cords are plugged or un-
plugged with the power cord
left plugged in, malfunction or
damage may result.
3. When arranging the system
units in a vertical, stacked con-
figuration, observe the stack-
ing order indicated in the sys-
tem connection diagram.
4. In case an associated system
component is connected, also
read the instruction manual of
the component.
5. Align the front panels of all sets
flush.
6. Never short-circuit the + and –
speaker cords.
7. If the left and right speaker con-
nections or the + and – polarity
are inverted, the sound will be
unnatural with unclear position-
ing of musical instruments, etc.
Be sure to connect them with-
out mistake.
Notes
Notes
Twist
Speaker Unit
To maintain proper ventilation,
be sure to leave a space around
the unit (from the largest outer
dimensions including projec-
tions) equal to, or greater than,
shown below.
top panel: 50 cm
rear panel: 10 cm
left and right panels: 10 cm
System connection
Speaker (left)
3214
Please install as shown below, as oth-
erwise fire may be caused by overheat-
ing.
Caution regarding placement
(Front View)
The external view is variable depending
on the model and marketing destination
type.
Main unit
Twist
3214
Connection of parallel cord
From the top to the bottom
Amplifier :A-H5
Tuner/Equalizer:C-H6 or C-H5
CD player :DP-H5 or DP-MH5
Cassette deck :X-H5
