Bedienungsanleitung Kenwood xd dv 55 (Seite 68 von 73) (Englisch)

158076

Zoom out

Zoom in

Vorherige Seite

1/73

Nächste Seite

Knowledge

XD-DV series (EN/K,M,T,X,Y)/2

÷ Connect properly referring to “System con-

nection”.

÷ Switch MUTE OFF.

÷ Unplug the headphone plug.

÷ Connect properly referring to “System con-

nection”.

÷ This is not malfunction. Press the DISPLAY/

DEMO key to cancel the demonstration.

÷ Adjust the present time again.

÷ Adjust the present time referring to “Clock

adjustment”.

÷ Set the timer ON time and OFF time.

÷ Execute the timer program.

÷ Connect antennas.

÷ Select a band.

÷ Tune to the frequency of the desired sta-

tion.

÷ Install the outdoor antenna in an apart posi-

tion from the road.

÷ Switch the suspected electric appliance OFF.

÷ Install the TV or the system at an increased

distance between them.

÷ Preset stations with tunable frequencies.

÷ Preset stations again.

÷ Check the speaker connection.

÷ Set the surround speaker switch on the

rear of the unit to ON.

÷ The speaker cords are disconnected.

÷ The MUTE switch of remote control unit is

switched ON.

÷ The headphone plug is inserted into the

jack.

÷ The speaker cords are disconnected.

÷ The DEMO is set to on.

÷ There was a power failure.

÷ The power cord was unplugged from the

outlet.

÷ The present time has not been adjusted or

there was a power failure.

÷ The timer ON time and OFF time have not

been set.

÷ The timer execution was not set up.

÷ The antennas have not been connected.

÷ A proper broadcasting band has not been

selected.

÷ The frequency of the station to be received

is not tuned.

÷ Car ignition noise.

÷ Influence of an electric appliance.

÷ A TV set is installed near the system.

÷ The frequency of the preset station is not

tunable.

÷ The preset memory has been cleared be-

cause the power cord has been unplugged

for a long period.

÷ The speaker connection is abnormal.

÷ The surround speaker switch on the rear of

the unit is set to OFF.

What seems to be a malfunction is not always so. Before calling for service, check the following table according to the symptom

of your trouble.

Operation to reset

The microcomputer may fall into malfunction (impossibility

to operate, erroneous display, etc.) when the power cord is

unplugged while power is ON or due to an external factor. In

this case, execute the following procedure to reset the

microcomputer and return it to normal condition.

÷ Please note that resetting the microcomputer clears the

contents stored in and returns and to condition when it left

the factory.

Sound is not produced.

Sound is not produced from the left

or right speakers.

Demonstration starts suddenly.

The clock display is out of order.

Timer operation is not possible.

Radio stations cannot be received.

Noise interferes.

A station has been preset but it can-

not be received by pressing the

P.CALL key.

The STANDBY indicator flashes red.

Only XD-DV75/XD-DV65/XD-DV55;

No sound from the surround speak-

ers (option)

RemedyCauseSymptom

Receiver, speakers

(

‚

In case of difficulty

Set the POWE key to ON. Then press the VIDEO/

AUX key while holding the TUNING MODE key

down.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kenwood xd dv 55 Seite 68

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info