SD5
23
LFO 1 (DCO) Delay: This specifies the delay after which the LFO will affect theDCO to create the vibrato effect.
LFO 2 Rate: This establishes the speed of the LFO dedicated to the control of the filter and the amplitude.
LFO 2 (DCF) Depth: This specifies the operating intensity of LFO on the cut-off point of the filter, therefore generating a closing and opening
effect of the filter that, if the Resonance is set at high levels, can produce an effect somewhat akin to a wah wah effect.
LFO 2 (DCA) Depth: this specifies the operating intensity of the LFO on the amplitude which creates a tremolo effect.
Velocity Slope: This is used to modify the response curve to the Velocity for the User Voice being modified that, at zero, mutes the voice.
Velocity Filter: This controls the opening of the filter according to the key dynamics. Value 64 is the standard setting. Lower values obtain
a less brilliant sound, even when playing at high velocity.
Octave Shift: This shifts the octave of the User Voice by a range within - 2 octaves and +2 octaves.
SAVING A USER VOICE
An edited User Voice must be saved permanently in the memory otherwise it will be lost when the SD5 is turned off. The saving 'prompt' appears
automatically after any parameter has been modified and the user attempts to exit the programming menu using
EEXXIITT
, or by pressing
the
SSAAVVEE
push button to enable the saving procedure. In both cases the page that appears shows the destination in memory location with the
name of the User Voice already there at that time. To change the destination in memory directly, enter the destination number using the nume-
ric keypad
SSTTYYLLEESS
buttons. This page is also used to modify the name to be given to the User Voice, using the keys of the keyboard. To confirm
the procedure press
FF1100 SSAAVVEE
.
FF55 EEssccaappee
: This cancels the saving procedure. The new User Voice will be saved on the same source location.
SAVING ALL THE USER VOICES ON DISK
The entire contents of the User Voice bank can be saved on hard disk or floppy disk by using the following procedure:
●
Press
DDIISSKK
and select the destination disk using push buttons
PPAAGGEE ++//--
.
●
Go to the desired folder by entering the number using the numeric keypad relative to the
SSTTYYLLEESS
push buttons.
●
Enable the saving procedure using
FF33 SSaavvee
.
●
Select
FF1100 OOtthheerrss
and then
FF22 UUsseerr VVooiiccee
.
A page appears where the name of the file is to be entered using the keyboard keys.
Confirm the procedure using
FF1100 EExxeecc
, or cancel using
FF55 EEssccaappee
.
.
Voices and User Voices
