Bedienungsanleitung Kettler Run S - 07885-700 (Seite 12 von 84) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch)

736644

Zoom out

Zoom in

Vorherige Seite

1/84

Nächste Seite

INCLINE ADJUSTMENT

With the INCLINE button (+) the incline angle will be increased by

0,5 %.

With the INCLINE button (-) the incline angle will be decreased by

0,5 %.

Pressing and holding of this button leads to an automatic fast run

through the values.

SPEED ADJUSTMENT

ith the SPEED button (+) the speed can be increased during the

raining by 0.1 km/h (mph).

With the SPEED button (-) the speed can be decreased during the

training by 0.1 km/h (mph).

Pressing and holding of this button leads to an automatic fast run

through the values.

PULSE RECEPTION

The treadmill is equipped with a hand pulse detection. To gua-

rantee a good hand pulse detection both hand pulse sensors shall

be firmly and entirely covered by the hands without moving the

hands. Movements of the hands can lead to interferences. The

pulse display requires approx. 5 to 15 seconds to show your cur-

rent pulse.

The treadmill also comprises of an in-built POLAR compatible

heart rate receiver. To be able to use the wireless pulse system you

need to wear a chest strap for the transmission of the heart rate.

The chest strap for the transmission of the heart rate is not inclu-

ded in the scope of supply of this treadmill. We recommend the

POLAR Chest Strap T34. This can be purchased as additional

equipment in specialist shops.

Please remember that some materials used in your clothes (e.g.

polyester, polyamide) can cause electrostatic charging and possi-

bly prevent an accurate heart rate measurement. Please also con-

sider that mobile phones, televisions and other electrical devices

that create an electromagnetic field around them, might also

cause problems with the measurement of the heart rate.

ERROR MESSAGES

During the operation different messages will be shown in the dis-

play in case of an error of the control. Error messages can be

reversed by switching off and restarting of the power supply. If the

error message remains, contact the customer support.

MODE

TURN ON

First of all turn on the treadmill. The ON/OFF switch (I/O) for the

treadmill is located next to the mains cable on the front under-

neath the motor cover. Flip the switch to the "ON" setting = (I).

The total kilometres are displayed with odo XXXX.

SAFETY KEY

Always check that the safety switch works before every training

session. Insert the safety key into the safety switch and the cord to

your clothing. If the safety key is not inserted in the safety switch,

"SAFE - - - SAFE" appears on the display.

OK TRAINING

Always hold on tight to the handrails when getting on and off the

treadmill.

Stand on the treadmill's side platform before you start training.

Never start the treadmill while you are standing on it. Start your

training with a slow speed and then increase the speed or incli-

ne. Always run in the middle of the treadmill if possible.

Always keep your body and head facing forwards during the trai-

ning session. Never try to turn around on the treadmill while it is

moving.

TRAINING OPTIONS

MANUAL

Once the treadmill is turned on and the safety key is engaged

press the OK key. The treadmill will start after 3 seconds with 0,8

km/h (0,5 mph).

You can increase / reduce the speed or incline at any time during

the training session. To end the training session press the OK key.

When you manually start the training session, the training

distance and time display counts upwards. The manual program

is a training session with no time limit.

1. Turn on the treadmill.

2. Secure the safety key to the treadmill and the clip to the

user's clothing.

3. Press the OK key to start training.

MANUAL with time or distance input

Press the TIME or DISTANCE key before training. The relevant key

lights up bright. Input the values using the (-/+) keys. The TIME or

DISTANCE display counts down at the start of the training sessi-

on.

PULSE CONTROLLED

(key only lights up bright with pulse signal)

Target pulse before training (60 - 200)

Press the PULSE key. The display flashes. Input a value using the (-

/+) keys. Press the PULSE key again to confirm. During training,

the target pulse is controlled and held by adapting the speed and

incline (option) once the current pulse is in the range of -/+ 15

beats from the target pulse for at least 30 seconds. The speed can

be manually adjusted outside this range.

Pulse hold during training (PULSEHOLD)

Press the PULSE key. The current pulse becomes the target pulse.

PULSE lights up brighter. The target pulse is controlled and held

by adjusting the speed and incline (option).

Press the PULSE key or change the SPEED or INCLINE values to

end pulse control.

If pulse recording is interrupted during pulse control the speed

and incline are taken back to the minimum after 60 seconds and

the treadmill is stopped.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kettler Run S - 07885-700 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Kettler Run S - 07885-700

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info