772982
58
Zoom out
Zoom in
Vorherige Seite
1/82
Nächste Seite
MY20K10-02_1.0_10.11.2020 58
Cleaning and servicing
7.4.1.4 Checking and adjusting the tyre
pressure – Presta valve
Only applies to S pedelecs with this equipment
It is recommendable to use
a bicycle pump with a
pressure gauge. The
operating instructions for
the bicycle pump must be
adhered to.
1Unscrew and remove the
valve cap.
2Open the knurled nut
around four turns.
3Carefully apply the bicycle
pump so that the valve
insert is not bent.
4Pump up the tyre slowly and pay attention to
the tyre pressure in the process.
5Correct the tyre pressure as per the
specifications on the tyre.
6Remove the bicycle pump.
7Tighten the knurled nut with your fingers.
8Screw the valve cap tight.
9Screw the rim nut gently against the rim with
the tips of your fingers.
7.4.1.5 Checking and adjusting the tyre
pressure – Schrader valve
Only applies to S pedelecs with this equipment
It is recommendable to use a
bicycle pump with a
pressure gauge. The
operating instructions for the
bicycle pump must be
adhered to.
1Unscrew and remove the
valve cap.
2Attach the bicycle pump.
3Pump up the tyre slowly and pay attention to
the tyre pressure in the process.
The tyre pressure has been adjusted as per the
specifications.
4Remove the bicycle pump.
5Screw the valve cap tight.
6Screw the rim nut (1) gently against the rim
with the tips of your fingers.
7.4.2 Brake system
The maintenance interval for the brake depends
on the weather conditions and how frequent the
bicycle is used. If the S pedelec is used under
extreme conditions such as rain, dirt or high
mileage, maintenance must be performed more
frequently.
7.4.3 Checking the brake linings for wear
Check brake linings after brake has been fully
applied 1,000 times.
1Check that the brake linings are no less than
1.8 mm wide at any point and no less than
2.5 mm between the brake lining and
supporting plate.
2Push brake lever and hold. In doing so, check
the transport safety wear gauge can fit
between the brake lining supporting plates.
The brake linings have not reached their wear
limit. Contact your specialist dealer if any of
these components have become worn.
7.4.4 Checking the pressure point
Push brake lever and hold several times.
If you are unable to clearly detect the pressure
point and it changes, the brake needs to be
bled. Contact your specialist dealer.
Crash caused by brake failure
Worn brake discs and brake linings, as well as a
lack of hydraulic fluid in the brake cable, reduce
the braking power. This may cause a crash with
injuries.
Check the brake disc, brake linings and
hydraulic brake system on a regular basis.
Contact your specialist dealer if any of these
components have become worn.
CAUTION
!
1
58

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Kettler Velossi 2.0 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Kettler Velossi 2.0

Kettler Velossi 2.0 Bedienungsanleitung - Deutsch - 83 seiten

Kettler Velossi 2.0 Bedienungsanleitung - Holländisch - 82 seiten

Kettler Velossi 2.0 Bedienungsanleitung - Französisch - 84 seiten

Kettler Velossi 2.0 Bedienungsanleitung - Spanisch - 85 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info