• Ensure product is level, securely fastened to the cabinetry and opens and closes freely. The
must be free to close with no resistance from the cabinetry.
• Ensure inlet hose to valve connection is tightened a further half turn after seal contact.
• Ensure any knockouts or plugs in drain connection have been drilled out and drain connection has been
made.
• Turn ON the power and water supply. The should beep and light up.
• Open the drawer(s) and check operation of Wash Programme Control Panel and check the sprayarm(s)
are in place and free to rotate.
• On the Wash Programme Control Panel select Rinse and close the drawer(s). Start the programme by
pressing the Start/Pause button.
• After the Rinse programme has finished, ensure machine has run and drained correctly.
• Check water supply and drainage connection for leakage.
• Repeat for each Drawer.
- LEAVE ALL LITERATURE WITH CUSTOMER.
TROUBLE SHOOTING
• Excessive water remaining above the filter plate, after the rinse cycle; check for kinked drain hoses or
blocked waste connection.
• No water supply; check water is connected, ON and there is water pressure.
• does not light up when the tub is opened; ensure power is connected and is switched ON.
• Water around water supply and drainage connections - check connections, existing plumbing and hoses
for leaks.
• If a fault occurs, consult the Fault Code Section of the User Guide.
• If unable to resolve, contact your Customer Care Centre.
Step 11: Final checklist (double and single models)
21
If you have any questions concerning the installation of this , please see your User Guide or
Warranty information for contact details.
