16
What to do if...
If a fault occurs, before contacting the After-sales Service, make the following checks to
try and remedy the problem. Most faults can be remedied by taking the following
courses of action, quickly restoring normal appliance operation.
How the faults are shown on the display: Function number “F”x - blinking Error number “E”y - blinking
0.5 sec. pause
The appliance... Possible causes... Solutions...
...is not working/will not start • The appliance must be switched on. • Check the household circuit fuse if
there is no power supply.
• The dishwasher door doesn’t close. • Check if the dishwasher’s door is
closed.
• “Delayed start” option is ON. • Check whether the “Delayed start”
option (if available) has been
selected. If it has, the appliance will
only start once the set time has
elapsed. If necessary, RESET the
appliance by pressing CANCEL or
start the cycle immediately by
pressing START.
...shows “F6 E2” • Water tap closed. • The water tap must be open.
• Kinked water inlet hose or clogged
inlet filters.
• The water inlet hose must not be
kinked and the relative inlet filter in
the water tap connector must not
be clogged.
...shows “F6 E7” or “F6 E1” • Water pressure too low. • The water tap must be fully open
during water inlet (minimum
capacity: 0.5 litres per minute).
• Kinked water inlet hose or clogged
inlet filters.
• The water inlet hose must not be
kinked and the relative inlet filter in
the water tap connector must not
be dirty.
...shows “F6 E3”/wash program
ended too early (dishes are dirty
and wet)
• Dirty or clogged filters. • The filters must not be dirty or
clogged.
• Too little water in the dishwasher’s
water system..
• Concave items (e.g. bowls, cups)
must be arranged facing
downwards in the rack.
• Drain hose incorrectly fitted. • The drain hose must be fitted
correctly (for high mounted
appliances, leave min. 200-400 mm
from the lower edge of the
appliance) - see Assembly
instructions.
• High level of foam inside. • Repeat without detergent or wait
until foam disappears.
...shows “F8 E1” • Dirty filters. • Clean the filters.
• Kinked drain hose. • The drain hose must not be kinked.
• Syphon hose connection closed. • The closure disk of the syphon
hose connection must be removed.
