9
Operation
Use the high suction speed in cases of concentrated
kitchen vapours. It is recommended that the cooker
hood suction is switched on for 5 minutes prior to
cooking and to leave in operation during cooking
and for another 15 minutes approximately after
terminating cooking.
T1. Hood OFF
Press the button and the hood passes from
operation, in any suction mode, to OFF.
T2. “Silent” mode
This mode is not associated with any specific type
of cooking.
Press the button to activate the hood in silent mode.
Press button T1 or T2 and the hood passes to OFF.
T3. “Boost” mode
This mode is not associated with any specific type
of cooking.
Press the button in the case of particularly intense
fumes.
Press button T1 or T3 and the hood passes to OFF.
T4. Lighting ON/OFF
Press the button to turn the lights on or off.
T5. Cooking mode
Press the button cyclically to activate the different
suction modes.
Each mode is associated with different types of
food cooking.
This is to obtain optimum suction according to the
different needs.
A signalling LED corresponds to each suction
mode.
• “Slow cooking” mode LED L1 on
Press the button when cooking vegetables in a
pan, when heating food or drinks (milk, coffee,
tea).
• “Boiling” mode LED L2 on
Press the button when cooking sauces, broth,
boiled vegetables and soups, or when boiling
food (e.g. pasta).
• “Grilling” mode LED L3 on
Press the button when cooking food on grill or
griddle.
• “Frying” mode LED L4 on
Press the button when frying food (e.g. meat,
potatoes, vegetables).
To quit the selected suction mode press the
following buttons:
Button T1 hood in OFF
Button T2 activation of “Silent” mode
Button T3 activation of “Boost” mode
Fault alarm
In case of motor fault (stall, overheating, etc.) all
the functions of the motor will be blocked (except
for lighting) buttons T2, T3, T5 and LEDs L1, L2,
L3, L4 will flash.
Once the alarm has gone off, the hood goes back to
OFF.
Press button T1 and the hood passes to OFF.
If the fault persists, the hood remains in the alarm
state and all the functions are blocked. Contact the
technical service.
