9
After unpacking the product, check for any damage during transport.
In case of problems, contact the dealer or the After-Sales Service.
For built-in dimensions and installation instruction, see the pictures in page 5.
PREPARING THE CABINET FOR FITTING
- Install a separator panel under the hob.
- The lower part of the product must not be accessible after installation.
- Do not fit the separator panel if an undertop oven is installed.
• The distance between the underside of the appliance and the separator
panel must respect the dimensions given in the figure.
• In order to ensure the correct operation of the product, do not obstruct
the minimum required clearance between the hob and the top of the unit
(min. 5 mm).
• If an undertop oven is installed, make sure the oven is equipped with a
cooling system.
• Do not install the hob above a dishwasher or washing-machine, so that
the electronic circuits do not come into contact with steam or moisture
which could damage them.
• In the case of flush-mounted installation, call the After-Sales Service to request assembly of screws kit
4801 211 00112.
• To remove the hob, use a screwdriver (not provided) to prise off the perimeter clips on the underside of
the appliance.
WARNING
Installation
- Disconnect the appliance from the power supply.
- Installation must be carried out by qualified personnel who know the current safety and
installation regulations.
- The manufacturer declines all liability for injury to persons or animals and for damage to
property resulting from failure to observe the regulations provided in this chapter.
- The power cable must be long enough to allow the hob to be removed from the worktop.
- Make sure the voltage specified on the dataplate located on the bottom of the appliance is the
same as that of the home.
WARNING
Electrical connection
