1. After cleaning the surfaces around the edges, fit the seal
provided around the hob.
2. Position the hob inside the opening according to the sizes
indicated in the description sheet.
3. Use the brackets (A) provided to secure the hob, fixing it with
the proper screws to adapt it to the thickness.
Seal around the edges
• Position the seal on the support flange.
• You should seal around the edges to prevent the infiltration of
liquids that could damage the appliance or the worktop.
Warning: the electrical power cable must be long enough
to allow the hob to be lifted out from above.
Securing the hob into cabinetry
If you are using a different kind of gas from the one
indicated on the serial no. plaque and the orange
label on the back of the hob, you must replace the
injectors; in the case of the Wok burner, adjust the
primary air (see Injector table).
The orange label should be removed and kept
together with the manual.
Use pressure regulators suitable for the gas
pressure indicated in the description sheet.
• In order to replace the injectors, contact the
Customer Care Centre or a qualified electrician.
• Injectors not supplied as standard should be
requested from the Customer Care Centre.
• Regulate the minimum levels of the taps.
Note: With liquid petroleum gas (G30/G31)
the by-pass screw must be screwed in deeply.
If you then experience difficulty in turning the
button, contact the Customer Care Centre
who will arrange for the tap to be replaced
after ascertaining that the tap is damaged.
Adaption to different kinds of gas
15
A
Silicon sealing
External seal