13
Instructions for use
Automatic power down (limiting the working time)
The limitation of the working time is a function of the touch control, for turning off the generator. In
relation to the cooking level set, each cooking point is turned off after a certain maximum operating time
unless the set cooking time has been changed.
Any change in the status of the cooking point with these assigned keys resets the maximum operating time
of that cooking point to the starting value of the limitation of the operating time.
Timer function
The Timer function can be used as a timer for the cooking point or as an independent alarm clock.
The two 7 segment displays of the respective cooking zones are used to view the remaining time in
minutes up until the timer alarm is activated.
Timer selection
The timer value is displayed on the display behind the cooking points.
There are two different time modes:
- Timer for the cooking point: the timer is assigned to a cooking point. When the set time runs out, there
is an audible and visual signal and the relative cooking point turns off.
- alarm for cooking: the timer works independently from the cooking point. When the set time runs out,
there is an audible and visual signal in this mode as well, but the cooking points are not turned off.
Selecting a timer:
a timer is selected by simultaneously pressing the plus and minus keys with the control activated.
If you have previously selected a cooking point, the timer of that cooking point will light up. Plus, this will
be indicated by the flashing decimal point on the display of the cooking point.
If no cooking point had been previously selected, the cooking alarm timer will be activated. In this case, all
the decimal points will be off.
If different timers are active, you can select the desired timer by pressing the plus and minus keys several
times.
If a timer was set for the cooking point and also a generic timer, when the selection time has elapsed (10
seconds) the timer with less time is shown on the upper display so, if a timer of, for example, 1 minute was
set on the cooking area and the generic cooking timer was set for 2 minutes, 01 will be displayed and the
selection decimal point will continue flashing. Conversely, if the cooking area timer was set to, for
example, 4 minutes and the generic cooking timer was set to 3 minutes, the timer will display 03 and the
selection decimal point of the cooking area will remain on to indicate that a timer is set.
The selection time is 10 seconds. This time is set from scratch at each change of the value of the timer by
pressing the plus or minus key.
You can end the selection early by selecting a cooking point.
POWER LEVELS OPERATING TIME LIMIT (MINUTES)
1 480
2 360
3 300
4 300
5 240
6 90
7 90
8 90
9 90
P 0
