11
- Use protective gloves.
- Ensure the oven is cold before carrying out the following
operations.
- Disconnect the appliance from the mains power supply.
REMOVING THE DOOR
To remove the door:
1. Open the door fully.
2. Lift the catches and push them forwards as far as they will go (fig. 1).
3. Close the door as far as it will go (A), lift it up (B) and turn it (C) until it is
released (D) (fig. 2).
To refit the door:
1. Insert the hinges in their seats.
2. Open the door fully.
3. Lower the two catches.
4. Close the door.
WARNING
Maintenance
(fig. 1)
(fig. 2)
REMOVING THE SIDE GRILLES
The side accessory-holder grilles are equipped with two fixing screws (fig. 3)
for optimum stability.
1. Remove the screws and relative plates on the right and left with the aid
of a coin or tool (fig. 4).
2. To remove the grilles, lift them up (1) and turn them (2) as shown in
fig. 5.
REPLACING THE LAMP
To replace the rear lamp (if present):
1. Disconnect the oven from the mains power supply.
2. Unscrew the lamp cover, replace the lamp (see note for lamp type) and
screw the lamp cover back on.
3. Reconnect the oven to the power supply.
N.B:
- Only use 25-40W/230V type E-14, T300°C incandescent lamps, or 20-
40W/230 V type G9, T300°C halogen lamps.
- The lamp used in the appliance is specifically designed for electrical
appliances and is not suitable for household room illumination
(Commission Regulation (ES) No 244/2009).
- Lamps are available from our After-Sales Service.
IMPORTANT:
- If using halogen lamps, do not handle with bare hands
sincefingerprints can damage them.
- Do not use the oven until the lamp cover has been repositioned.
(fig. 3)
(fig. 4)
(fig. 5)
