11
In General
• On unpacking you wine cabinet after delivery, check for any
obvious exterior damage (dents, malformation, etc.).
• Open the door and check that the inside of the appliance is
complete and in good condition (walls, shelves, hinges,
control panel, etc.).
• In the event of a problem, contact your dealer.
• Move your wine cabinet to your selected location. This
location should not be a confined space. There should be
space to allow air to flow around the cabinet. (not placed in
a cupboard, etc.)
• Away from any heat source
• Not too wet (wash room, utility room, bathroom, etc.)
• Be on a flat solid floor
• Never place your wine cabinet in a location liable to
flooding.
• Avoid splashing water onto the base of the appliance.
• Install the drip tray (which you will find inside your cabinet’s
"accessories" box) on the compressor support at the back of
the cabinet, locating it under the small pipe protruding from
the housing, the lower part of the tank being placed under
this pipe (see Fig. 1).
• Take the power lead (which you will find inside your
cabinet’s “accessories" box) and connect it to the socket
provided at the rear bottom left of the cabinet (see Fig. 2).
• Unwind the power supply lead so that it can be accessed
and place the appliance leaving a space between 8 and 10
cm (3" 1/8 to 4") space between the wall and the back of
your wine cabinet.
• Place the power supply lead so that it is not in contact with
any of the appliance’s components.
IMPORTANT - Wait 48 hours before switching on to
allow the fluids contained in the internal circuits to
settle.
• Gently incline the wine cabinet backwards in order to adjust
the front feet (screw adjustment) so that your wine cabinet
stands perfectly level (we recommend using a regular spirit
level).
• Remove the protective items located inside your wine
cabinet. (Do NOT remove the cabinet bracing bar)
• Install the carbon filter, which you will find inside your
cabinet’s “accessories" box , by placing it in the air
circulation hole located inside the cabinet on the top left
hand side (see Fig. 3).
• Beware: any changing of the control panel LED should only
be carried out by a qualified electrician.
• Never connect several wine cabinets to a multi-socket.
N.B.: when moving your wine cabinet, do not incline it
more than 45°,and always toward side where the power
lead is located.
Installing your wine cabinet
Fig. 1
Fig. 2
Fig. 3
