12
How to adjust the temperature for different requirements
Each model has been carefully tested before
leaving the factory and is adjusted in such a way to
ensure high performance and low consumption.
Usually, it is not necessary to modify the settings.
Nevertheless, according to special needs, it is
possible to modify the set temperatures as follows:
Refrigeration Compartment
From +2°C to +8°C (from 35.6°F to 46.4°F), the
recommended preset temperature is +5°C (41°F).
To adjust the temperature use the Up/Down buttons
.
Upon touching these buttons the newly set
temperature will appear in the display. To modify
this temperature, use the buttons until reaching the
desired temperature.
Dynamic 0° Compartment
From -2°C to +2°C (from 28.4°F to 35.6°F), the
recommended preset temperature is 0°C (32°F).
To adjust the temperature use the Up/Down buttons
.
Upon touching these buttons the newly set
temperature will appear in the display. To modify
this temperature, use the buttons until reaching the
desired temperature.
Freezer Compartment (Multi-temperature)
From -15°C to -22°C (from 5°F to -7.6°F), the
recommended temperature is preset at -18° (0°F).
To adjust the temperature use the Up/Down buttons
.
Upon touching these buttons the newly set
temperature will appear in the display. To modify
this temperature, use the buttons until reaching the
desired temperature.
In case the compartment is used as refrigerator or
Fresco compartment (TriMode function) the
recommended and preset temperatures will
correspond to those indicated for the respective
compartments.
The temperature shown can vary slightly in
respect to the set temperature following frequent
openings of the doors or insertion of room
temperature foods or large quantities of foods.
6 to 12 hours are necessary to reach the selected
temperature.
Ice Maker Activation
The Ice Maker button located on the main
control panel permits activation of the automatic
icemaker.
The button is lighted when the icemaker is
functioning.
A prewash of the hydraulic circuit should be
performed before activating the Ice Maker for the
first time. To do this touch at the same time buttons
Enter and Ice Maker .
After a few minutes the Ice Maker can be activated.
Do not activate the Ice Maker unless the
appliance is connected to the water mains.
An integrated control system provides information through lighted signals or text messages visualized on
the display.
The information signal is always visualized with a fixed text message, while a malfunction signal is
visualized with blinking text.
The sound signal that accompanies some malfunction signals can be deactivated by pressing the Alarm
button on the main control panel.
The list of malfunction signals is located at the back of this manual.
Information and malfunction messages on the display
