II. FITTING INSTRUCTIONS
SPF 1 SA-ATS is classified in the SEMI-UNIVERSAL category
and can be installed in two different methods:
METHOD A: For vehicles equipped with Isofix anchor
points (cf. list “A” compatible vehicles).
METHOD B: For vehicles equipped with three-point sa-
fety belt (cf. list “B” compatible vehicles).
Method A: Installing the car seat using the Iso-fix con-
nectors
Rotate the support leg so that it is in an upright position
(Fig. 2).
To prepare the child seat installation, press simultaneou-
sly the two levers, on either side of the child seat base (Fig
3 - A) and push completely the support leg release unit
(Fig. 3 - B), to extract the connectors (Fig. 3 - C).
SPF 1 SA-ATS comes with two plastic guides (Fig. 1 - U);
you can use them, if your vehicle has none, to guide the
Isofix connectors in their proper position in correspon-
dence of the seat anchor points of your car.
Line up the two plasic guides with the Isofix connecting
points (Fig. 4 ).
Place the child seat on the appropriate vehicle seat, facing
forward.
Ensure the vehicle seat is locked in the most upright and
adjusted to the rearward position.
Make sure that the connection indicators are red (Fig. 5
A), suggesting that the connectors are ready for engage-
ment. If one or both indicators are green, press the button
(Fig. 5-R).
Insert simultaneously the two Isofix connectors through
the child seat guides, pushing the support leg articulation
(Fig. 5-B) to lock them in.
Important: You must clearly hear two distinct “clicks” and
both indicators should be green (Fig. 5 - C). Only in this
case the connectors are properly attached to the anchor
points of the seat.
Adjust the height of the support leg by pressing the pu-
shbutton located at its back (Fig. 6) and slide down the
lower section until it reaches the floor of the vehicle.
Release the button and check that the support leg is lo-
GB
