784314
56
Zoom out
Zoom in
Vorherige Seite
1/64
Nächste Seite
56
Installation
8.2 Important information befo-
re installing the appliance:
Clean the environment thoroughly
before and aer installation so that
no dust or construction debris can be
sucked in during initial operation.
Check the condition and load-bearing
capacity of the electrical cables.
The installation of the appliance by a
specialist is recommended.
Follow the description of the work steps
in the mounting chapter and all further
instructions.
In the execution with air exhausted out-
doors, the vapours are extracted via an
air exhaust hose xed to the connector
ring.
The diameter of the exhaust air hose
must conform to that of the connector
ring.
The exhaust air hose must not be led
through a sha together with gas
pipes, hot air pipes etc.
Route the exhaust hose as straight as
possible away from the hood.
The maximum permissible bend to the
outside is 120°.
If a smoke non-return valve is used or
is planned, check whether it can open
and close freely aer the installation of
the exhaust air hose.
8.3 Using the extractor hood as
an exhaust air hood (with air
extracted to outdoors)
If the extractor hood has been tted at
the factory with a carbon lter, this must
be removed for exhaust air operation.
It is only practicable to use this when
operating your hood in circulation
mode
.
8.4 Converting the extractor
hood to a circulation hood
If you wish to use the hood as a circulati-
on hood, you must mount the activated
carbon lter(s) to the fan motor before
using the hood. If not included in the
scope of supply, you must obtain the
carbon lter(s) from the supplier of your
extractor hood.
8.5
Mounting the carbon lter
Disconnect the appliance from the
power supply.
Loosen the screws of the motor unit
and remove it.
Screw the activated carbon lters
onto the motor housing (usually
clockwise).
56

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für KKT Kolbe DRAFT600 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info