Bedienungsanleitung KKT Kolbe EBM8018S (Seite 55 von 60) (Deutsch, Englisch)

784260

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

Cleaning and maintenance

Slide-in rails

For thorough cleaning of the rails and the cavity, you can

remove the side racks as follows / shown in the ugure.

• Take off the white ceramic / plastic elements. (1.1).

• Lift the side rack. (1.2).

• Now you can take out the side rack. (1.3).

To replace the side racks after cleaning, proceed in rever-

se order.

Note: Take particular care to reattach the ceramic / plastic

elements as well. These are absolutely necessary for safe

microwave operation. Otherwise damage may occur that is

not covered by the warranty.

1.1

1.2 1.3

Appliance door

For cleaning purposes, the appliance door can be de-

tached.

The appliance door hinges each have a locking lever.

When the locking levers are closed, the appliance door is

secured in place. It cannot be detached.

When the locking levers are open in order to detach the

appliance door, the hinges are locked. They cannot snap

shut.

Caution! Risk of injury!

• If the hinges are not locked, they can snap shut

with great force. Ensure that the locking levers

are always fully closed or, when detaching the

appliance door, fully open.

• The hinges on the appliance door move when

opening and closing the door, and you may

be trapped. Keep your hands away from the

hinges.

Attention! Risk of damage!

Failure to comply with the following instructions

may result in damage to the appliance that is not

covered by the warranty:

• Do not put any weight on the appliance door,

do not hang anything on it and do not place

anything on it.

• Always close the appliance door slowly and

in a controlled manner and t it carefully after

unhooking it.

Removing the appliance door

• Open the appliance door fully.

• Open the two locking levers left and right fully (2.1).

• Close the appliance door as far as it will go.

• With both hands, grip the door on the left- and right-

hand side and lift it until the door is completely

released from its anchorage.

!Fitting the appliance door

Reattach the appliance door in the opposite sequence

to removal.

• When tting the appliance door, make sure that both

hinges are inserted exactly into the corresponding

mounting holes and that they can be pushed in without

resistance. If you feel resistance, check the position of

the hinges.

• Open the appliance door completely. When opening the

appliance door, you can check again that the hinges are

in the correct position. If you carry out the assembly

incorrectly, you will not be able to open the appliance

door completely afterwards.

• Close both locking levers again (2.2).

• Close the appliance door. By the same time , we warmly

recommend you to check one more time , if the door

is onto the right position and if the ventilation slots are

not half-sealed .

2.1

2.2

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

KKT Kolbe EBM8018S Seite 55

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info