Bedienungsanleitung Klarstein Speed Iron - 10026364 (Seite 11 von 19) (Deutsch, Englisch, Französisch, Italienisch, Spanisch)

705340

Zoom out

Zoom in

Vorherige Seite

1/19

Nächste Seite

Steam function setting:

After power on, set temperature control dial to steam ironing position. Heating the indicator light on an iron

unit lights up to indicate the unit being heated up. When desired temperature has been reached, heating in-

dicator light turns off, it is ready for using. During use, heating indicator light will cycle from ON to OFF and

then OFF to ON, it indicates that the iron is automatically heat preservation. Press steam button to start steam

ironing. When you adjust the temperature control dial, steam rate will be adjusted accordingly. MAX steam will

be obtained when set at MAX position, it will be smaller gradually when turn to 〃WOOL/SILK〃

position.

Note: When temperature control dial is located at SYNTHETIC 〃, it is proposed not to activate steam ironing

since temperature is too low to produce steam, it only suits for dry ironing,

Steam Ironing

1. Fill water tank with clean tap water.

2. Connect the unit into a suitable main socket. Turn temperature control dial to steam ironing position.

3. Before first time use of steam ironing, please clean the iron as below methods: Take the iron unit up from

the base unit, press steam button underneath the handle to allow steam release for 30 seconds and then

stop for 30 seconds, do so as a cycle, and repeat above cycle again. The iron is not ready for using until the

heating indicator light turns OFF.

4. During steam ironing, steam rate will be varied when temperature control dial is adjusted to different posi-

tions. This can prevent water leakage caused from soleplate.

5. After using, take the iron unit back onto base unit,turn temperature control dail to ¨MIN〃, and then unplug

from main socket. Slide water tank out from the base unit and empty it.

NOTE: For every first time use, it is normal thatˇs a slightly vibration sound may be occurred from electrical pump

inside the base unit for a few seconds when steam ironing started. If this abnormal conditions coutinuously hap-

pen for more than 60 seconds, please check whether water tank and filter assembled correctly or not.

Vertical steam ironing:

Follow the steam ironing process, and then hold the iron in vertical position between 5cm and 15cm away from

the hanged fabrics. Press down steam switch, this will create vertical steam. This feature is especially used for

removing creases from hanging clothes and curtains. Never directly perform steam ironing on people. (Fig.8)

Handle

Handle attached to the

base unit used to carry the

appliance. Before use, press

down two handle buttons

synchronously, and then lay

the handle down. (Fig.9) Af-

ter use, allow the appliance

completely cool down, be-

fore you lift handle up until

a ¨pa〃 sound is provided.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Klarstein Speed Iron - 10026364 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info