Bedienungsanleitung Klipsch KSW 150 (Seite 14 von 16) (Englisch)

584798

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

How to Connect Your

KSW Series Subwoofer

The subwoofer should be unplugged from the AC power with the power switch in the OFF position

during hook up and installation.

AC Power

A detachable AC power cord is supplied with your KSW Series subwoofer. Install the female end

into the recessed socket on the right-hand side of the ampliﬁer panel. Refer to Figures B, C and D

(pages 8 and 9). To eliminate a tripping hazard, this cord and all other connections should be

unplugged from the back panel of the subwoofer if it is being moved. Note: The 230 volt KSW 300

and dual voltage KSW 50, 100, 150 and 200 export versions are not supplied with an AC power

cord. The 120 volt KSW 50 has a non-removable AC power cord.

Since your KSW subwoofer has an internal power ampliﬁer, it must be plugged into a nearby AC

wall outlet. A three-prong grounded outlet is recommended wherever possible. Note: Avoid extremely

long extension cords of small gauge since they can reduce the amount of current available to the sub-

woofer ampliﬁer, degrading its performance and presenting a potential ﬁre hazard.

Types of Connections

Your subwoofer may be installed using either the “HI LEVEL” or “LINE” connections, but not both.

With both types of connections, your main speakers can be run full range or high pass ﬁltered (bass

frequencies removed). Your main speakers can be bass ﬁltered by your KSW Series subwoofer if con-

nected in a speciﬁc manner. Refer to Figures B and C

(pages 8 and 9)

and the “HI LEVEL OUT,”

“LINE OUT,” “LOW PASS” and “HIGH PASS” sections for more detail. The type of input and con-

nection scheme depends upon the capabilities of your equipment and your performance goals.

HI LEVEL

“HI LEVEL” (speaker level) connections are the best choice when connecting to a receiver or inte-

grated ampliﬁer that lacks a line level subwoofer jack or pre-amp output jacks. Refer to Figures A

and B (page 8).

LINE IN

“LINE IN” (line level) connections are often the best choice when connecting the subwoofer to a

system comprised of a separate pre-amp and power ampliﬁer. This also applies to any receiver or

integrated ampliﬁer that possesses line level main channel pre-amp outputs or a subwoofer output.

Refer to Figures C and D (page 9).

HI LEVEL SPEAKER WIRE CONNECTIONS

About Speaker Wire Connections

When making any type of speaker wire connection be sure to observe proper polarity. Most speaker

wire is color-coded or has some distinguishing feature differentiating the two conductors. Speaker

wire connectors on most loudspeakers and ampliﬁers are also color-coded. Typically, RED is positive

(+) and BLACK is negative (-), or ground. It does not matter which wire conductor is connected to

the positive or negative connection of your equipment as long as you are consistent. Be sure that the

connections from the amp to the speaker on all of the various channels of your system are connect-

ed in a like manner. Be careful not to have excess bare wire or loose strands of wire that could short

from positive to negative as this could damage your speakers and ampliﬁer.

HI LEVEL IN

The “HI LEVEL IN” connections are hooked up to the main or front right and left speaker outputs

of your ampliﬁer. Use the same high quality speaker cable that you would run to your main speakers

(consult your Klipsch dealer for recommendations). Be sure to observe proper polarity (+ to + and -

to -) when making connections between the subwoofer and main ampliﬁer. If the polarity of one of

these wires is reversed, the output of the subwoofer will be diminished. Refer to the “About Speaker

Wire Connections” section and Figures A and B (page 8).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Klipsch KSW 150 Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info