Bedienungsanleitung Klipsch SW-110 (Seite 4 von 24) (Deutsch, Englisch, Französisch, Portugiesisch, Spanisch)

588371

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

system is completely hooked up. If your receiver does not have a crossover point

setting, set the Lowpass Filter on the subwoofer instead within the same recom-

mended settings (see receiver manual for additional speaker setup info).

“PHASE” 0/180 - This control is used to acoustically match the subwoofer’s

output to your main speakers. Select the position, either 0° or 180°, in which your

subwoofer has more output at the listening position.

“POWER” AUTO/ON/OFF - This is the main A/C power switch for the subwoofer.

This switch must be in the “ON” position for the subwoofer to operate and for

the “AUTO/ON” switch to function. Set this switch to the “OFF” position if the

subwoofer will not be used for an extended period of time (i.e. vacation).

When this switch is in the “AUTO” position, the subwoofer will automatically turn

“on” when it senses a signal. It will automatically turn “off” after 20 minutes with

no signal. When this switch is in the “ON” position, the subwoofer will remain “on”

as long as the “POWER” ON/OFF switch is in the “ON” position. When this switch

is in the “OFF” position, the subwoofer will remain “off” as long as the “POWER”

ON/OFF switch is in the “OFF” position.

Power LED indicator - Located on the front bafﬂe, this LED indicates the operat-

ing status of the built-in ampliﬁer. The LED will light green when the ampliﬁer is

on and receiving a signal. If the LED is dark and not lit, the ampliﬁer is off. For

more information on the controls mentioned in this manual and on bass manage-

ment, see your dealer or visit www.klipsch.com.

CARE AND CLEANING OF YOUR POWERED SUBWOOFER

Your subwoofer has a durable vinyl ﬁnish that should only require dry dusting or

cleaning with a dry cloth. Avoid the use of abrasive or solvent-based cleaners and

harsh detergents. The brush attachment of your vacuum should remove any dust

from your subwoofer enclosure.

FCC AND CANADA EMC COMPLIANCE INFORMATION

NOTE: This equipment has been tested and found to comply with the limits for

a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not in-stalled and used in accordance with the instruc-

tions, may cause harmful interference to radio communications. However, there

is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged

to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Approved under the veriﬁcation provision of FCC Part 15 as a Class B Digital Device.

Caution: Changes or modiﬁcations not expressly approved by the manufacturer

could void the user’s authority to operate this device.

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

The term “IC:” before the radio certiﬁcation number only signiﬁes that Industry

Canada technical speciﬁcations were met.

This equipment complies with FCC and IC radiation exposure limits set forth for

an uncontrolled environment. This equipment should be installed and operated with

minimum distance 20cm between the radiator and your body. This transmitter must

not be co-located or operating in conjunction with any other antenna or transmitter.

Le terme «IC:» avant le numéro de certiﬁcation radio signiﬁe seulement que les

spéciﬁcations techniques d’Industrie Canada ont été respectées.

Cet appareil est conforme à FCC et IC l’exposition aux rayonnements limites

ﬁxées pour un environnement non contrôlé. Cet appareil doit être installé et utilisé

avec une distance minimale de 20 cm entre le radiateur et votre corps. Cet trans-

metteur ne doit pas être co-situé ou opérant en liaison avec toute autre antenne

ou transmetteur.

Operation is subject to the following two conditions: (1) this device may not cause

interference, and (2) this device must accept any interference, including interfer-

ence that may cause undesired operation of the device.

To reduce potential radio interference to other users, the antenna type and its gain

should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not

more than that permitted for successful communication.

EU COMPLIANCE INFORMATION:

Eligible to bear the CE mark, Conforms to European Union Low Voltage Directive

2006/95/EC; Conforms to European Union EMC Directive 2004/108/EC and

European Union Directive 2005/32/EC for Ecodesign requirements.

WEEE NOTICE

Note: This mark applies only to countries within the European Union (EU) and Norway.

This appliance is labeled in accordance with European Directive

2002/96/EC concerning waste electrical and electronic equip-

ment (WEEE). This label indicates that this product should not be

disposed of with household waste. It should be deposited at an

appropriate facility to enable recovery and recycling.

PRODUCT REGISTRATION

• Klipsch will keep you up-to-date on new products and promotions

• Your personal information will never be resold

• This registration information is not used for warranty purposes.

Please retain your receipt for warranty claims.

Klipsch is a registered trademark of Klipsch Group Inc.

Klipsch SW-110 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info