Bedienungsanleitung Koenic KFZ 521 E NF (Seite 22 von 26) (Deutsch, Englisch)

782830

Zoom out

Zoom in

Vorherige Seite

1/26

Nächste Seite

Note: The alarm function is activated

at any moment and will indicate a rapid

increase of the internal temperature. In

addition an acoustical signal will sound.

Child lock - Key lock: If this

function is activated, no settings can

be changed. However, the key lock can

be disabled in the same way as it is

activated.

Fig. 7To switch the freezer on and o, press

and hold the ON/ OFF switch OK/

5S for at least 5 seconds. This allows

the freezer to be switched on and o

without using the mains plug.

Fig. 8If you need ice cubes ﬁll the ice cube

tray with water. Place the ice cube

maker in the freezer and wait several

hours. If the liquid is suciently frozen,

turn the knobs (a, b) to the right and

then release them. The ice cubes fall

into the tray. If necessary shake the

ice cube maker together with the

collecting tray.

Adjust the side of the hinges

Attention

Make sure that the freezer stands safely

during work and cannot tilt.

Note:

• If necessary, and if the premises require it,

the mounting of the doors can be changed.

To do this, follow below instructions in the

given order.

• The following tools are required:

Socket wrench 8 mm, wrench 8mm, phillips

screwdriver, slotted screwdriver. Due to

the uniqueness of the appropriate tools,

those are not mentioned separately in the

following instructions.

• For this work a dierent hinge holder and

cover are needed, which are provided with

the unit.

Caution

• Pull out the mains plug!

• The mounting should be performed by at

least 2 persons to avoid dangers.

1 Pull o the top cover. If necessary use a

plastic card or spatula to loosen the cap.

2 Disconnect the plug and socket.

3 During unscrewing hold the refrigerator door

or it might be damaged. Remove the three

screws of the top hinge.

4 Pull out the door and place it on a soft and

clean surface.

5 Remove the blind cap on the top of the

freezer (use a plastic card or spatula to help

loosen the cap) and insert it into the holes

on the right side.

6 Pull o the front panel and place the cable

as shown.

7 Make sure the LED light bar is seated in the

guides and attach the front panel back to

the front.

8 Loosen the two caps on the top of the door.

9 Insert the end of the cable into the hole and

close it with the blind cap.

Pull the other cable out and close the hole

with the cap having the cable gland.

Loosen the angled plate on the bottom of

the door and screw it on the other side. Do

not turn the metal plate and note that the

small holes must be placed on the plastic

pins while the screw hole and the tapped

hole must be aligned.

Loosen the three screws on the lower

hinge plate and remove it. If necessary tilt

the refrigerator to get better access to the

bottom side.

Unscrew the hinge pin and screw it back on

the other side.

Place the hinge plate on the left side into

position.

Tighten the hinge plate securely.

Place the door on the lower hinge pin.

Keep the door in position. Take the additional

hinge provided and insert the hinge pin into

the corresponding hole in the door. Hold the

hinge plate in position and screw it.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Koenic KFZ 521 E NF Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info