Bedienungsanleitung Koenic KFZ 531 E NF (Seite 22 von 145) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch, Schwedisch)

782831

Zoom out

Zoom in

Vorherige Seite

1/145

Nächste Seite

English

Cleaning and care

Warning

• Unplug the product before cleaning.

• When cleaning, never use solvents or

abrasive materials, hard brushes, metallic

or sharp objects. Solvents are harmful to

human health and can attack plastic parts,

while abrasive cleaning materials and tools

may scratch the surface(s).

• Never use oil or grease on the door seal.

This will make it porous over time.

• Do not use steam cleaning equipment. The

steam may come in contact with electrical

parts of the product, causing a short circuit.

• Clean the product’s exterior surfaces with

a slightly damp cloth and then dry them

thoroughly.

• Make sure that no water enters the product

interior (e.g. at the control panel).

• Wipe the door seal with clean water only, and

dry it thoroughly afterwards.

• Removable parts e.g. glass shelves, can be

taken out for cleaning.

Decommissioning

If a longer break should occur during operation

of the refrigerator, the following steps must be

carried out:

• Empty the product.

• Unplug the product.

• Clean the interior of the freezer

compartment and let it dry.

• Carefully clean all the accessories (vegetable

containers, door compartments, glass

shelves, etc.)

• Let the door open to avoid the formation of

unpleasant odors and mold.

Installing the door handle

Remove the two blind plugs at the desired

side of the door.

Screw on the handle with the provided screws.

Clip the two provided caps onto the screws.

Caution

After you have placed the freezer upright

on its feet, wait for 24 hours before you

connect it to the mains to permit the cooling

system to regain full capacity.

Energy saving tips

• Do not place the product in the vicinity of a

heat source (radiator or kitchen stove, etc.).

• Ensure unobstructed air ﬂow around the

refrigerator and freezer.

• If an ice layer has built, defrost the unit. A

thick ice layer aects the transmission of the

cold, thus the energy consumption will be

increased.

• When opening and taking out food, only

open the door shortly. A shorter door

opening time causes less ice to deposit on

the freezer walls.

• Select the temperature regulator setting

according to the ﬁlling amount of the

product.

• Use drawers, baskets or shelves to store the

food. If the energy of the product is used

eciently, the energy consumption can be

minimized.

• It’s advised not to remove the provided

accessories, such as drawers, shelves

balconies, as this might increase the energy

consumption.

IM_KFZ 511 E NF_KFZ 531 E NF_210219_V09_HR.indb 22IM_KFZ 511 E NF_KFZ 531 E NF_210219_V09_HR.indb 22 19/2/2021 2:40 PM19/2/2021 2:40 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Koenic KFZ 531 E NF Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info