Bedienungsanleitung Konig Electronic HC-AH50 (Seite 10 von 147) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

533208

Zoom out

Zoom in

Vorherige Seite

1/147

Nächste Seite

ƽ Attention

• The water tank may leak if it is subject to misuse

• Stop using the humidifier immediately if water leakage occurs and contact an appointed maintenance

centre

Maintenance after cleaning

1. Wipe off water after cleaning, air dry the water tank and body of the device until completely dry.

2. Make sure there is no water left inside the water tank or the body of the device.

3. Assemble the water tank and body of the device and put into a plastic bag. Pack it in the original

colour box and store in a place of low humidity.

ƽ Attention

• The humidifier will become mouldy and may develop malfunctions if it is stored when not completely

dry.

Troubleshooting

• In case something abnormal happens, please refer to the troubleshooting guide

• If you cannot solve the problem(s), please contact your nearest maintenance centre

Abnormal condition Possible cause Correction method

Has the plug been plugged into the

socket correctly?

Plug in correctly

No misting

Is the red light on the “Add Water”

indicator flashing on and off? (Is the

water tank empty?)

Add water to the water tank

Operating under weak mode?

(Is the display screen show “weak”?)

It is not a malfunction. If you want to change

to strong operating mode, press the “Misting

Amount” button under the personal setup

mode and change to strong operation mode

Poor misting

Is there water scale on the surface of

the atomizer?

Clean the atomizer

Have you chosen “Using Warm mist”

under the personal setup mode?

Press the “Warm Mist” button under

personal setup mode and change to using

warm mist to humidifying operation

Without warm mist

Has the operation just begun?

This is not a malfunction. It takes about ten

to twenty minutes to emit warm mist. (The

time needed for the heater to warm up the

water after it has been turned on)

Is there any dust inside the air inlet?

Clean the air inlet. Even in the same room,

the humidity can vary

The difference between

current humidity and

hygrograph is too big

Is the device being operated in places

easily influenced by the environment

such as near a window?

Please put the device in places less likely to

be influenced by the environment

Is stale water being used?

Mist with strange smell

Is there any water scale or rubbish

inside the water slot or atomizer?

Please clean the device according to the

instructions on cleaning and maintenance

and replace with fresh water

With ‘pupu’ sound

The sound of filling water from water

tank to the body

with ‘popo’ sound

The sound for fan operation

It is not a malfunction, keep on using

• Correct method: It is not a malfunction, please keep on using.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Konig Electronic HC-AH50 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info