707347
11
Zoom out
Zoom in
Vorherige Seite
1/36
Nächste Seite
Basic operations
11
Introduction
Selecting parameters on the display
and changing values
Use the buttons shown below to select parameters or change
values on the display.
2 341
1.
p
button,
q
button
Use these buttons to move the cursor (the black stripe) up
and down in the display. You can change the parameters
selected with the cursor on the display by using the dial or
the buttons.
2. Dial
This is used to change numbers and values.
Turn the dial clockwise to increase the value, and turn the
dial counter-clockwise to decrease the value.
3. + and – buttons
• Press the + or – button once to increment or decrement a
number.
• Holding down a button will make the number continue to
change.
4. CATEGORY
t
,
u
(CANCEL, ENTER) buttons
Performance mode and Sequencer mode:
Pressing these buttons when selecting a sound set or style
will select the setting of the first grouped category.
Setting mode and Media mode:
This cancels or executes the function displayed.
Using the joystick
Vibration of sound,
brightness, etc.
Pitch
y
Move the joystick to the left and right to change the pitch
of the keyboard part.
Tip:
You can set the range of pitch bend using “PitchBend
Range” in Setting mode (page 26).
Note:
The pitch may not change for some sounds.
y
Move the joystick up and down to change the sound of
the keyboard part.
Tip:
How much the sounds will change when you move the
joystick depends on the sound set you have selected.
Adjusting the tonal character
(equalizer)
You can use the equalizer to adjust the tonal character of the
i3’s sound as you like. The HIGH knob affects the high-frequen-
cy range, and the LOW knob affects the low-frequency range.
You can use these knobs while playing.
Listening to the demo songs
The i3 has three built-in demo songs. You can check out the
sounds of the i3 by listening to the demo songs.
1.
Hold down the EXIT (SHIFT) button and press the SEQ
button.
The demo songs will start playing back in order. You can
switch to a different demo song while another song is play-
ing back, by using the dial or the +/– buttons.
1
1
2.
Press the EXIT (SHIFT) button to exit.
Turning on the metronome
You can use the metronome to guide you as you’re playing.
Tip:
The metronome will sound at the current tempo settings.
To change the tempo, see “Changing the tempo” (page 17).
1.
Hold down the EXIT (SHIFT) button and press the TAP
TEMPO (METRONOME)
button.
The metronome will sound.
1
1
2.
Hold down the EXIT (SHIFT) button and press the TAP
TEMPO (METRONOME) button once more to stop the
metronome.
Tip:
You can change the metronome volume from
“Metronome Level” in Setting mode (page 27).
11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Korg i3 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Korg i3

Korg i3 Bedienungsanleitung - Deutsch - 36 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info