Bedienungsanleitung Korg microKORG S (Seite 71 von 73) (Englisch)

707422

Zoom out

Zoom in

Vorherige Seite

1/73

Nächste Seite

Troubleshooting

Before you suspect a malfunction, please check the following points.

Power does not turn on

❏ Is the AC adaptor connected to an AC outlet? ➝p.6

❏ If you are using batteries, are batteries installed? Have the batteries run down?

➝p.6

No sound

❏ If your powered monitor system or headphones connected to the correct

jack(s)? ➝p.5

❏ Is the connected monitor system powered-on, and is the volume raised?

❏ Is the VOLUME knob set to a position where sound will be output? →p.6

❏ Is the MIDI "LOCAL" setting turned ON? →p.51

❏ Were any volume-related parameters set to a value of 0? →p.23, 27, 34, 37

❏ Was the FILTER "CUTOFF" set to 0? →p.24

❏ Did you turn the FORMANT HOLD key on ("E.F. SENSE" HOLD) while there

was no input to AUDIO IN 1? ➝p.10, 35

Can’t input sound

❏ Is the input source connected to the AUDIO IN 1 CONDENSOR jack or

DYNAMIC jack, or to the AUDIO IN 2 LINE jack? ➝p.10, 21, 34

❏ If you are inputting to AUDIO IN 1 or AUDIO IN 2, is the VOLUME 1 or

VOLUME 2 knob turned up? ➝p.10, 21, 34

❏ If you are inputting to AUDIO IN 1, is the MIC/LINE switch set appropriately?

➝p.4

❏ If using a vocoder program, have you connected the modulator audio source to

the AUDIO IN 1 CONDENSER jack or DYNAMIC jack? ➝p.10

❏ If you have connected an input device to the AUDIO IN 1 CONDENSER jack and

also to the DYNAMIC jack, the input from the CONDENSER jack will take

priority, and no signal can be input from the DYNAMIC jack. ➝p.4

Can't edit

❏ If the display does not switch to the parameter indication when you turn the

edit control knobs 1–5, Performance Edit may be active. ➝p.8, 12

❏ If you are unable to use the edit control knobs 1–5 to edit the parameter value,

did you remember to turn the knob to a position that matches the displayed

value? ➝p.13

❏ If you are unable to edit timbre 2 of a synth program, has VOICE "SINGLE/

LAYER" been set to LAYER? ➝p.14, 16

❏ If you are unable to edit timbre 1 or 2 of a synth program, is the TIMBRE SELECT

1/2 LED lit for the timbre you want to edit? ➝p.14

❏ If the changes you made to a program or to the global settings have not been

remembered, did you turn the power off before executing the Write operation? In

the case of a program, your edits will also be lost if you select a different program.

Execute the Write operation to save your edits before you switch programs or turn

off the power. ➝p.58

Can't write programs or global settings

❏ Is Shift function “MEMORY PROTECT” turned OFF? →p.64

❏ If an edited program or edited GLOBAL, MIDI, or SHIFT settings you thought

you had saved have not actually been saved, did you set the EDIT SELECT 1 or

EDIT SELECT 2 dial to one of the VOICE–ARPEG.B position when you at-

tempted to save the program, or to the GLOBAL or MIDI position when you

attempted to save the global data? ➝p.58

Arpeggios do not start

❏ Is the arpeggiator turned on (ON/OFF key lit)? →p.11

❏ Is the MIDI "CLOCK" setting correct? ➝p.51

No response to MIDI messages sent from an external device

❏ Is the MIDI cable connected correctly? →p.48

❏ Does the MIDI channel of the data transmitted from the external MIDI device

match the MIDI channel of the microKORG S? →p.49

Does not respond correctly to MIDI messages sent from an external device

❏ Is the SHIFT function "MIDI FILTER" for that type of MIDI message set to Enable?

➝p.61

Transpose, velocity curve, and arpeggiator data is not recognized correctly

❏ Is MIDI "POSITION" set appropriately? →p.47

Can't control two timbres on separate MIDI channels

❏ The microKORG S uses only one MIDI channel to transmit and receive. You

cannot use two MIDI channels to play the two timbres independently.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Korg microKORG S Seite 71

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Korg microKORG S

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info