Bedienungsanleitung Kranzle e-therm 500 M 24 (Seite 12 von 29) (Englisch)

716902

Zoom out

Zoom in

Vorherige Seite

1/29

Nächste Seite

22 23

This means that the temperature increases far above the desired value or falls

far below the desired value. The innovative new percent mode now lets the user

specify the switching duration of the heater in percent using the "+" and "-" but-

tons (Pos. 3+4) (100% being the max. temperature) rather than setting the desired

temperature. Now the result of the setting must be checked by using the "Actual"

temperature display. If the desired temperature has not yet been reached, the

percentage must be increased.

By setting percentages of the heating duration, the temperature of the

high-pressure jet is kept constant in a very narrow range.

The last value set is also saved after the unit is switched off in percent mode.

Operating hour meter

The cleaner is equipped with an operating hour meter. If during normal opera-

tion the momentary operating mode button ( "°C" or "%" ) is actuated for more

then 2 seconds, the operating time of the pump is displayed for 5 seconds and

afterwards the combustion time for 5 seconds as well. Thereafter the display

shows the original values again. As long as the operating hours are displayed

no further inputs on the monitor are possible.

The operating time is displayed in hours [ h ] either in the “TARGET” or in

the „ACTUAL“ window. The 1000 and 100 hours are displayed in the „TARGET“

window and the 10, 1 and 1/10 hours in the “ACTUAL” window:

Pump operating time: Target-Display: P 9 9 Actual-Display: 9 9. 9 for 9 999,9h

Combustion time: Target-Display: F 9 9 Actual-Display: 9 9. 9 for 9 999,9h

e.g.: F00 27.3 = Cumbustion time 27 hours and 18 minutes

The thermostat has two operating modes:

1. Temperature mode

This mode is always activated when the unit is switched on or can be selected

using the "°C°" button (Pos. 5). The red LED above the "°C" button and next

to the set temperature display lights up.

The desired "Set" temperature is set using the two buttons (+/-, Pos. 3+4) and

can be read in the upper display (Pos. 1). If you press the button for a longer time,

the set temperature is quickly adjusted in 5 °C increments.

The last set value set is also stored after the unit is switched off and is available

again immediately after switching back on. The current spray temperature can

be read from the bottom display (Pos. 2)

2. Percentage mode

This mode is activated by pressing the "%" button (Pos. 6). The yellow LED above

the "%" button and next to the set temperature display flashes.

In the temperature control of high-pressure cleaners in temperature mode (“°C”),

the water temperature is measured at the outlet of the heater, and the heater

is switched on an off according to the temperature desired by the user.

Due to the large amount of water in the heating coil, it takes a long time

until the temperature sensor registers that the burner has switched on

and the desired temperature has been reached.

Thermostat

The thermostat controls the spray water tem-

perature. After you switch on the device, "888"

appears in both displays for approx. 1 second

as a test of the functioning of the displays.













Functional details Functional details

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kranzle e-therm 500 M 24 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Kranzle e-therm 500 M 24

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info