Bedienungsanleitung Kranzle LX-RP 1400 TST (Seite 8 von 19) (Englisch)

716896

Zoom out

Zoom in

Vorherige Seite

1/19

Nächste Seite

14 15

Check the line fusing and have the voltage and the available current

intensity checked by an expert in case of uncertainty (see technical data).

Elektroanschluss

The high-pressure cleaner is supplied with a 5 meter length of cable ﬁtted with

a mains plug. The plug needs to be inserted in a properly installed wall socket

equipped with a protective ground terminal and 30mA FI residual current circuit

breaker. Mains connection must be carried out by a suitably qualiﬁed electrician

and comply with IEC60364-1 requirements. The socket must be protected on the

mains side by a fuse having a time lag of at least 20 A (Type C, K). If use is made

of an extension cable this needs to be equipped with a protective conductor

properly connected up to the plug-in connections and revealing a minimum

cross-section of 2.5 mm

. The plug connections must be splash-proof designs

and must not be allowed to lie on a wet ﬂoor.

Required minimum quantity of water (see technical data).

If the metered quantity of water is too small, you have to use a

different water connection, guaranteeing the necessary output.

Lack of water leads to an accelerated wear of the joints (no warranty).

Never let the high pressure pump run dry for more than 60 seconds.

Water supply

Please pay attention to the regulations of your waterworks company!

In accordance with DIN EN 61770, the high-pressure cleaner may not

be directly connected to the public drinking water supply lines. A brief

connection however is permissible according to DVGW (German

Association for Gas and Water Affairs) if a non-return valve with tube

ventilator (Kränzle item no.: 410164) is built into the water supply.

Once the water has passed through the non-return valve it is no

longer considered as drinking water. Also indirect connection to

the public drinking water supply lines is permissible by way of free

emission in accordance with EN 61 770; e.g. by using a reservoir with

a float valve. Direct connection to a non-drinking water supply line

is permissible.

Insufficient quantity of electricity

Functional details Functional details

If there are too many collectors in your

proximity connected to the network at the

same time, the available voltage and the

current intensity may decline. Consequently

the motor of the high-pressure cleaner does

not start or even blows. The power supply

may also be insufficient if the power supply

cable is too long or too thin. If extension

cables are too long, this may lead to a

voltage drop causing malfunctions or

start-up difficulties.

Please note: Lack of water

Lack of water occurs more often than you

probably believe. The more powerful a high-

pressure cleaner is the greater is the danger

that a lack of water occurs. If there is only

an insufficient amount of water available,

cavitation (water-gas mixture) arises inside

the high pressure pump, which is normally

noticed too late or even not at all. The high

pressure pump will be destroyed. Please

check the available quantity of water by fil-

ling a bucket with liter scale for one minute.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kranzle LX-RP 1400 TST Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Kranzle LX-RP 1400 TST

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info