508535
13
Zoom out
Zoom in
Vorherige Seite
1/31
Nächste Seite
24 25
Functional details Functional details
Adjusting ignition electrodes
For a smooth ignition, the setting of the ignition electrode
must be controlled regularly.
Attention!
Immediately contact our service in case of recurrence.
Excess temperature sensor
As an additional safety device the high-pres-
sure cleaner is equipped with an excess tem-
perature sensor inside the chimney. Should
the safety devices as e.g. the float monitoring
device be defectice and the burner continues
to heat although the heating coil does not
conduct away heat a destruction of the
heating coil would be inevitable.
As soon as the temperature inside the
chimney exceeds 260 °C the excess tem-
perature release triggers and cuts out the
appliance. The display of the excess tempe-
rature sensor is located on the back of the
switchbox inside the high-pressure cleaner.
Trooble shooting excess temperature
see chapter „Small repairs - do it yourself!“
in these operating manuel.
Heat exchanger
The water is forced through a heating coil by the high-pressure pump.
The fuel pump sucks the fuel oil from the fuel tank via a fuel filter an and trans-
ports it to the injection nozzle. The heat exchanger is heated by a high-pressure
fan heater. A ventilator draws in the cold, fresh air from the bottom end of the
high-pressure cleaner and forces it upwards between the outer mantle and the
inner mantle. In the process, the fresh air is pre-heated and the outer mantle of
the heat exchanger is cooled.The pre-heated air is pressed through a mixing unit.
Here finely atomized fuel is injected via a nozzle and mixed with the air.
The electrodes located below then ignite the fuel-air mixture. The flame burns
from top to bottom, turns round and the hot gas flows past the heating coil
on its way back up. The burned gases collect in the exhaust chamber and are
emitted from the exhaust gas outlet.
1. Exhaust gas outlet
2. Mixing unit and nozzle
3. Electrodes
4. Inner cladding
5. Outer cladding
6. Fuel filter
7. Fuel pump
8. Heating coil
9. Fan
13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Kranzle Therm 1165-1 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Kranzle Therm 1165-1

Kranzle Therm 1165-1 Bedienungsanleitung - Deutsch - 44 seiten

Kranzle Therm 1165-1 Bedienungsanleitung - Holländisch - 44 seiten

Kranzle Therm 1165-1 Bedienungsanleitung - Französisch - 31 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info