Bedienungsanleitung Kranzle Therm 1165-1 (Seite 21 von 31) (Englisch)

508535

Zoom out

Zoom in

Vorherige Seite

1/31

Nächste Seite

40 41

Particular rules, directives and inspections

Inspections performed by Kränzle

- Measurement of earth line resistance

- Measurement of voltage and current

- Inspection of tension consistency with +/- 1530 V

- Pressure check of heating coil at 300 bar

- Visual and functional check as per the inspection sheet provided

- Exhaust fume analysis (see test strips provided)

Guidelines for liquid sprayers

The machine conforms with the "Guidelines for liquid sprayers". These guidelines

are issued by the organisation of trade associations and may be obtained from

Carl Heymann-Verlag KG, Luxemburger Str. 49, 50939 Köln. These guidelines

specify that this machine is to be inspected by qualified personnel whenever

necessary, but no less than once every 12 months. These inspections must be

recorded in the inspection log at the end of this manual.

Pressure container and steam boiler directives

Kränzle high-pressure cleaning equipment conforms to the pressure container

and steam boiler directive. No construction approval, notification of licence

and takeover inspection are required. The water capacity is less than 10 l.

Duties of owner

The owner is to ensure that all safety-relevant components are in a serviceable

condition before the sprayer is used. (e.g., safety valves, hose and electric cables,

spray equipment etc.)

Emission control legislation

With stationary installation, the emission levels of the machine must be checked

once a year by a qualified organisation or person according to German law. The

first inspection must be carried out four weeks after the machine is commissioned.

The owner is responsible for having the inspection performed.

Care and Maintenance

Weekly, or after approx. 50 hours of operation

Oil level

Check the oil level of the high-pressure pump at the oil gauge rod. If the oil level is

too low top up oil. The oil level must reach the upper edge of the "OK" mark. (Oil

change - see chapter „General rules“ in these operating manuel. Change the oil

if it has a grey or whitish appearance. The oil should be disposed of responsibly.

Water filter and fuel filter

Check the water filter in front of the float valve in the water tank and the fuel

filter in front of the solenoid valve. Clean the filters if necessary.

The machine must be disconnected from the power supply when servi-

cing work is being carried out. The main switch should be in position "0"

and the plug out of the socket.

Yearly, or after approx. 500 hours of operation:

- Desulphurise and decarbonize the heating coil.

- Check heating coil for calcification, decalcify if necessary.

- Check the oil burner and ignition system.

- Clean the oil nozzle, oil filter, solenoid valve and filter, clean and adjust

the ignition transformer, ignition cable and ignition electrodes and

replace defective parts.

- Change the oil

Oil leakage

If oil leaks contact your nearest after-sales service (dealer) at once.

(environmental damage, damage to the transmission).

In case of increased humidity or fluctuations in temperature

development of condensed water is possible. If the oil turns grey

or white, you must change it.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kranzle Therm 1165-1 Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Kranzle Therm 1165-1

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info