Bedienungsanleitung Kranzle Therm 715 (Seite 12 von 29) (Englisch)

716899

Zoom out

Zoom in

Vorherige Seite

1/29

Nächste Seite

22 23

Functional details

Please note: Lack of water

Lack of water occurs more often than you

probably believe. The more powerful a high-

pressure cleaner is the greater is the danger

that a lack of water occurs. If there is only

an insucient amount of water available,

cavitation (water-gas mixture) arises inside

the high-pressure pump, which is normally

noticed too late or even not at all. The high-

pressure pump will be destroyed. Please

check the available quantity of water by ﬁl-

ling a bucket with liter scale for one minute.

Required minimum quantity of water (see technical data).

If the metered quantity of water is too small, you have to use a dif-

ferent water connection, guaranteeing the necessary output. Lack of

water leads to an accelerated wear of the joints (guarantee void).

Water supply

Please pay attention to the regulations of your waterworks com-

pany! In accordance with DIN EN 61770, the high-pressure cleaner

may not be directly connected to the public drinking water supply

lines. A brief connection however is permissible according to DVGW

(German Association for Gas and Water Aairs) if a non-return val-

ve with tube ventilator (Kränzle order no. 41.016 4) is built into the

water supply. Once the water has passed through the non-return

valve it is no longer considered as drinking water. Also indirect

connection to the public drinking water supply lines is permissible

by way of free emission in accordance with EN 61 770; e.g. by using

a reservoir with a ﬂoat valve. Direct connection to a non-drinking

water supply line is permissible.

Insucient quantity of electricity

Functional details

If there are too many collectors in your

proximity connected to the network at the

same time, the available voltage and the

current intensity may decline. Consequently

the motor of the high-pressure cleaner does

not start or even blows. The power supply

may also be insucient if the power supply

cable is too long or too thin. If extension

cables are too long, this may lead to a volta-

ge drop causing malfunctions or start-up

diculties.

Check the line fusing and have the voltage and the available current in-

tensity checked by an expert in case of uncertainty (see technical data).

Electrical connection

The high-pressure cleaner is supplied with a 5 meters long power supply cable.

The mains plug must be ﬁtted to a standard grounded socket with a 30 mA

residual current operated device. The socket must be protected with a 16 A fuse

on the mains side. When using an extension cable, this must have an earthed

lead which is properly connected to the socket. The conductors in the extension

cable must have a minimum cross section of 1.5 mm². Plug connections must

be of a spray-proof design, and may not be located on a wet ﬂoor. For extension

cables of more than 10 m in length, the minimum cross-section must be 2.5 mm²!

When using a cable drum, the power supply cable always must be unwound all

the way.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kranzle Therm 715 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Kranzle Therm 715

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info