Bedienungsanleitung Kranzle therm-RP 1200 (Seite 9 von 29) (Englisch)

716908

Zoom out

Zoom in

Vorherige Seite

1/29

Nächste Seite

16 17

Oil change

The first oil change should be carried out

after approximately 50 operating hours,

then every year or after 500 operating

hours. If the oil turns grey or white, you

must change the oil.

Remove the large right hood from the

high-pressure cleaner and release the oil

drain hose from the inside of the device.

It is connected to the oil drain screw. Then

open the yellow oil filling plug at the top

of the black oil housing and then the closure

cap at the end of the hose. The oil is to be

caught in the reservoir and disposed of in

an approved manner. Close the end of the

hose. Only then top up fresh oil.

New oil: 0.8 l

Kränzle High Performance Gear Oil

(Item no.: 400932)

General rules General rules

Intended use

This high-pressure cleaner is to be used solely for high-pressure water jet cleaning

applications without detergents or low-pressure cleaning work with detergents

(e.g. with a foam injector or washing brush).

Environmental, refuse disposal and water protection regulations

must be observed!

Inspections

The high-pressure cleaner was finally inspected by the company Kränzle

(refer to Kränzle final report).

The high-pressure cleaner must be inspected according to the “Guidelines for

Liquid Spray Devices” at least once every 12 months by a qualified person, to

ensure that continued safe operation is guaranteed. The results of the inspection

are to be recorded in writing (see "Inspection reports" in these operating manual).

High-pressure cleaners used for commercial purposes have

to be checked by a qualified person at least every 12 months!

The owner is to ensure that all safety-relevant components are

in a serviceable condition before the high-pressure cleaner is used.

Accident prevention

The high-pressure cleaner is designed for accidents to be impossible if used

correctly. The user is to be notified of the risk of injury from hot machine parts

and the high-pressure jet. The “Guidelines for Liquid Spray Devices” must be

complied with.

During the combustion process air is needed and exhaust gas emerges.

If the high-pressure cleaner is operated in a confined space, precautions

have to be taken to safely exhaust the fumes. Furthermore a sufficient

ventilation has to be provided for.

Never shut the exhaust gas outlet on top of the If the high-pressure

cleaner. Never stoop over this aperture and never reach into it.

Emerging gases are extremely hot!

Oil leakage

If oil leaks contact your nearest after-sales service (dealer) at once.

Failure to observe this instruction may cause damage to the environment

and/or transmission gearbox.

In case of increased humidity or fluctuations in temperature

development of condensed water is possible. If the oil turns

grey or white, you must change it.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kranzle therm-RP 1200 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Kranzle therm-RP 1200

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info