Bedienungsanleitung Kratki K8 (Seite 11 von 120) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Finnisch)

813935

Zoom out

Zoom in

Vorherige Seite

1/120

Nächste Seite

is supplied together with the defective equipment.

The warranty card is valid if:

- it has been properly completed and shows the purchase date, seal and signature;

- the purchase date shown in the warranty card is the same as that shown on the receipt or a copy of

the invoice.

Automatic Air Supply System (ASDP) – System

The bimetal based, self-regulating thermostat auto-

matically controls the supply of air to the hearth, and consequently controls the combustion tempera-

ture inside the freestanding stove.

Before lighting the stove set the opening angle of the thermostat so as to ensure free air ow to the

hearth and open the air inlets in the door and on the stove front..

It is recommended to open the thermostat initially (through experimentation) at 60%; then you will

obtain an optimal combustion temperature for a 3,5 - 4kg large batch of wood. Once the batch is lit

close the air inlets in the door and on the stove front. As the temperature in the replace is growing, the

thermostat starts to perform its function: while closing gradually, it reduces the amount of air in the

combustion chamber. When the optimal temperature of 300°C is reached, air supply is largely reduced,

resulting in the stove’s temperature falling down until the minimum temperature necessary to mainta-

in the re is achieved. When the temperature drops below 250°C, air supply starts to be automatically

opened and combustions becomes more intense once again. To obtain a higher combustion tempera-

ture, you should set a larger opening angle of the thermostat before lighting the stove.

When the thermostat is in place, you can reduce the amount of wood needed to burn by 30% as com-

pared with the stove without an automatic combustion control system. In addition to wood savings,

this solution improves the comfort of the stove’s use; there is no need to keep checking and adjusting

air supply in the door and on the stove front to maintain proper combustion: the thermostat will do

this for you.

SPARE PARTS

If after many years some parts have to be replaced, please contact the vendor or any representative

of our company. When ordering spare parts, please name the details from the rating plate shown on

the reverse side of the warranty card, which should be retained even after the expiry of the warranty

period.

Having these details and our factory documentation, the vendor will be able to supply all spare parts

within a short time and proceed with repairs as part of their responsibilities. NOTE: Cracks that may

occur in vermiculite boards are natural for this type of material and do not aect its utility values.

NOTE: Do not use any air exhaust equipment in the room where the stove is installed (as required by

Polish laws).

MANUFACTURER

KRATKI.PL declines all liability for damage caused by the user’s modications of the unit and the rema-

ining piping system. To continually improve the quality of its products, KRATKI.PL reserves the right to

alter its equipment without prior notice.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kratki K8 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info