813988
42
Zoom out
Zoom in
Vorherige Seite
1/206
Nächste Seite
42
REPLACEMENT OF BATTERIES
Batteries in the receiver, remote control or the power supply module can overheat, spill or even cause
an explosion. Do not use batteries that have been exposed to the sun, moisture, heat or vibration.
Install only batteries of the same type and the same manufacturer. Do not install new batteries with
worn ones. The remote control is powered by two AAA batteries. The B6R-R8U receiver and the
G60-ZB90 power module are powered by four AA batteries 1.5V. The battery life in the case of the
remote control and the receiver is estimated at about 1 heating season. The device manufacturer re-
commends the use of alkaline batteries because of the lower risk associated with unsealing. It is also
permissible to use rechargeable batteries. When removing batteries, do not use tools that can cause
a short-circuit. Replacing batteries with conductive objects can permanently damage the electronic
components of the remote control and the receiver.
Replacement of the batteries in the remote control:
Remove the cover located on the rear of the remote control.
Gently remove the used batteries from the remote control.
Install new AAA batteries observing the polarity markings (+/-).
Replace the cover on the back wall of the remote
Replacing batteries in the receiver/power supply module:
Open the cabinet door panel.
Carefully remove the B6R-R8U receiver/G60-ZB90 power module.
Remove the cover.
Remove the used four AA batteries and install new, paying attention to the
polarity markings (+/-) on the receiver/power module.
Replace the cover on the cover receiver/supply module.
NOTE!!!
Replacing batteries in the receiver/power supply module can only be done on a cool replace
with the gas supply cut o.
NOTE!!!
Batteries are classied as hazardous chemical waste, so, after using them, they should not be
disposed of with other household waste.
MANUAL CONTROL
The user selecting the manual control option receives a device equipped with a GV32 controller. Ple-
ase read this manual before operating the control module. Proceeding contrary to the instructions
may result in damage to the gas control system or to the device itself, and may result in re, property
damage or health impairment.
USER MANUAL FOR THE MANUAL CONTROL MODULE
Firing the device should be carried out according to the instructions below. The GV32 gas control sys-
tem has been designed to completely eliminate the need for maintenance or any adjustments. The
knobs are non-removable. Removing the knobs will damage the device. Never attempt to open or
otherwise tamper with the valve or any of its components.
Starting the device:
1. Turn ON / OFF Knob A slightly counter clockwise towards the IGNITION position until it stops. Then
press and hold the knob for 5 seconds (the gas ows to the control burner only).
2. Continue to hold down the knob and at the same time turn it towards the PILOT position (this activa-
tes the piezo pilot of the control burner). Hold down the knob in this position for another 10 seconds
until the control burner ignites (if the pilot does not light up, repeat the procedure immediately
42

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Kratki PATIO MINI wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info