813972
18
Zoom out
Zoom in
Vorherige Seite
1/136
Nächste Seite
18
EN
Proper functioning of the insert can be interfered with by atmospheric conditions (humidity, fog, wind,
atmospheric pressure), and sometimes by closely located tall objects. In case of recurring problems,
seek the expertise of a chimney sweep or use a chimney cowl (e.g. reman).
Recognizing defects and how to deal with them
During operation of the replace stove, certain anomalies may occur indicating irregularities in the
operation of the stove. This may be due to improper installation of the replace stove without comply-
ing with current laws or the provisions of this manual, or due to external causes, such as the environ-
ment. The following are the most common causes of abnormal operation of the replace stove, along
with how to solve them.
Problem Possible cause Recommendations
Smoke retreat into the room
with the replace door open
- Rapid door release
- Closed windshield
- Poor room ventilation
- Inappropriate smoking
technique
- Poor chimney draught
- Bad weather conditions
- Open the door slowly
- Open the sunroof
- Ensure that the room is adequ-
ately ventilated in accordance
with the instructions
- Refuellate after obtaining the
ignition layer
- Check the chimney
- Install an exhaust fan or use a
ue cowl (e.g. reghter)
Phenomenon of insucient
heating or extinction of the
replace
- Low fuel consumption
- Too much wood humidity
- Too little chimney draught
- Inappropriate external air
supply
- Closed air damper
- Load the replace according
to the instructions
- Use wood with humidity up
to 20%
- Check the chimney
- Clean the duct and the air
supply grille
- Open the air damper
Phenomenon of insucient
heating despite good com-
bustion in the combustion
chamber
- Low calorie wood
- Too much moisture in the
wood used for combustion
- Too shredded wood
- Use wood according to the
instructions
- Use wood with humidity up
to 20%
- Use the pliers specied in the
instructions
Excessive soiling of the
chimney ue liner glass
- Low-intensity combustion
- Use of coniferous resinous
wood as fuel
- Lack of adequate air for
combustion
- Use only dry wood. Adjust the
amount of combustion air
- Use the wood provided for in
the manual
18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Kratki Zibi wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info