Bedienungsanleitung Kress KC711.9 (Seite 13 von 328) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Schwedisch, Norwegisch, Finnisch)

818719

Zoom out

Zoom in

Vorherige Seite

1/328

Nächste Seite

housing free of built-up grass. From time to time

turn off mower and wait for the blades to come

to a complete stop. Remove the batteries and

turn mower on its side. Using an object such as a

stick, wipe out any accumulation of grass around

the blade area. Be careful of the sharp edges of

the blade. Ensure to clean the blade area often

when cutting wet or new grass and every time

after the machine is used.

4) Certain types of grass or grass conditions may

require that an area be mulched a second time

to fully disperse the grass throughout the lawn.

If cutting a second time, it is advisable to cut

perpendicular (across) the rst cut pattern. DO

NOT CHANGE CUT PATTERN IN ANY WAY THAT

WOULD CAUSE MOWING DOWN A HILL.

5) Change your cutting pattern from week to week.

This will help prevent matting and graining of the

lawn.

6) Do not mow on a slope that has an angle of

greater than 20

CUTTING AREA

The cutting area can be affected by several factors,

such as cutting height, lawn humidity, grass length

and density. Besides, starting and stopping the

mower too many times during operation will reduce

the cutting area.

TIPS:

1) It is recommended to mow your lawn more

frequently, walk at normal pace, and not to start/

stop the mower too often during operation.

2) For best performance, please ensure battery pack

is fully charged and always cut off 1/3 or less of

the grass height. It is suggested to install a new

blade before the cutting season begins.

3) Walk slowly when cutting long grass, so as to

have more effective cutting and properly discharge

the clippings.

4) Avoid cutting wet grass, otherwise it will stick

to the underside of the deck and the clippings

cannot be collected or discharged properly.

5) A higher cutting height shall be applied to new or

thick grass and it will extend the battery duration.

Removing/emptying grass collection bag

(See Fig. L1, L2)

WARNING! Always check the safety ap has

closed the discharge outlet before using. Never

lift the safety ap or remove the mulching plug when

the lawn mower is being used without tted grass

collection bag.

FOR BATTERY TOOLS

The recommended ambient temperature range for

discharging is -20 °C~45 °C (-4 °F~113 °F).

The recommended ambient temperature range for

the charging system during charging is -5 °C~45 °C

(23 °F~113 °F).

TRANSPORTATION

Transporting the mower

1. Switch off the mower and remove the battery.

2. When transporting your mower, the self drive can

be used without enaging the cutting blade.

3. For lifting the mower, it is recomended that two

people lift from each side of the mower using the

motor guard and lower handle connection areas

as handles.

Transporting the battery

1. Ensure the battery is in a safe condition.

2. Use non-conductive packaging when

transporting the battery.

3. The contained Li-Ion batteries are subject to the

dangerous goods legislation requirements.

Transport batteries only when the battery

housing is undamaged. Pack up the batteries in

such a manner that cannot move around in the

packaging.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kress KC711.9 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info