Bedienungsanleitung KRK Systems Ergo (Seite 21 von 51) (Englisch)

705170

Zoom out

Zoom in

Vorherige Seite

1/51

Nächste Seite

Page | 21

20. 1394/Firewire considerations

a. The Firewire Bus

Most computers will generally be equipped with a single Firewire bus connection. You may have multiple

Firewire ports (connectors) on your computer, but these are all normally connected to one physical chip,

which controls the bus.

The Firewire bus is limited in the amount of data bandwidth it can handle. Each additional Firewire device

connected to the Firewire bus demands additional bandwidth resources, thus increasing the chances of

exceeded the total available bandwidth. Consequently, it is recommended that ERGO be the only device

connected to the Firewire bus for best possible performance. ERGO and other devices connected to the same

Firewire bus should work but of course there are limitations which are dependent on their use.

Problems may arise depending on which Firewire devices are connected. For example, a Firewire disk used

for back-up or a digital camera should not cause any problems, but when streaming audio from a Firewire

hard disk or a Firewire DSP Unit, the total Firewire bandwidth may be reached. This will result in audio

dropouts, or reduced performance on either ERGO or the other connected Firewire device. For this reason, we

would recommend that you use a separate Firewire bus for each Firewire device. This may be a PCI / PCIe card

in your desktop, or a PCMCIA or Express card in your Laptop. ERGO has been tested successfully with many

other devices, but cannot guarantee audio streaming as this is dependent on usage.

b. FireWire Chipsets

High definition audio flowing over FireWire requires a consistent stream between the chipset in the host

computer and the chipset in ERGO. Unfortunately, some FireWire chipsets have known issues when it comes

to the reliability and synchronization required for streaming audio. It is suggested to only use the best quality

branded PCI and PCMCIA cards from professional manufacturers.

c. FireWire Cables

Another issue that can degrade Firewire performance is cable quality. Many cables, even ones that feel like

quality cables, do not adhere to the IEEE 1394 specification. Improper shielding and/or grounding are

common causes of cable issues, always ensure you use the cable supplied with ERGO, or if connecting to a 4-

pin or 9-pin port, we advise purchasing high quality cables from good quality, branded suppliers.

d. Firewire Bus Power

This requires use of the 6-pin to 6-pin Firewire cable supplied with your product or the use of a 9-pin to 6-pin

cable (purchased separately)

Note: bus-power is only available on 6-pin and 9-pin Firewire connections, if connecting to a laptop which

only has a 4-pin Firewire connector you will need to use the external power supply and a 4-pin to 6-pin cable

(purchased separately).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

KRK Systems Ergo Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info