Bedienungsanleitung Krups EA8161 (Seite 19 von 156) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch)

711468

Zoom out

Zoom in

Vorherige Seite

1/156

Nächste Seite

Rinsing out the steam circuit:

Place a container under the steam nozzle and press the button for 3 seconds to start a steam circuit rinsing cycle,

which will automatically stop after around 300 ml.

Appliance cleaning program – total duration: about 13 minutes

When a cleaning operation is necessary, the appliance warns you of this by ashing the ‘CLEAN’ light.

This program is only accessible when the appliance requests it (i.e. approximately every 300 coffees or espressos).

To benet from the guarantee conditions, it is essential to perform the appliance cleaning cycle when in-

formed to do so. Be sure to follow the procedure closely, step by step.

Only use KRUPS cleaning tablets. You can obtain cleaning tablets from KRUPS Service Centres.

When the indicator light ashes, you can continue to use the appliance but it is recommended that you carry out the

program as soon as possible.

Start the cleaning program by pressing the button. The ‘CLEAN’ light becomes constant and the indicator lights

and ash.

Remove, empty and clean the coffee ground collector - Fig. 21.

Replace the coffee grounds collector – Fig. 22

Remove, empty and clean the drip tray - Fig. 23.

Put all parts back in place.

The light goes out.

Remove, ll and put the water tank back into place.

Place a container with a minimum capacity of 0.6l under the coffee outlets - Fig. 24.

Open the maintenance hatch - Fig. 25 and insert a KRUPS cleaning tablet (XS3000) in the cleaning duct - Fig. 26.

Press the button to start a cleaning cycle.

The rst phase (approximately 10 min) begins. At the end of this phase, the sound signal emits a beep every 10

seconds and you can empty the used water container and the drip tray.

Put the drip tray and container back in place for the next phase.

Press the button again to start the nal phase. The sound signal stops.

Final phase (±3 min)

The program continues. It rinses the appliance and removes any traces of cleaner.

When the cleaning cycle is nished, the indicator light ‘CLEAN’ goes out.

Remove and empty the used water container.

Empty the drip tray and put back into place.

Rell the water tank.

Your appliance is ready for the next use.

If there is not enough water in the water tank when you start the program, the light will come on to warn you. Add

the appropriate amount of water to the container and cleaning will continue automatically.

If you unplug the appliance during cleaning, press the button, or there is an electrical power cut, the

cleaning program will start again from the beginning. In this case, another cleaning tablet may be neces-

sary. Make sure to carry out the full cleaning cycle to ensure good maintenance of your appliance.

The cleaning cycle is intermittent: do not put your hands under the water outlets ‘E’ and ‘W’ while the cycle

is in progress.

Only use KRUPS (XS3000) cleaning tablets. We cannot be held responsible for any damage that may result from the

use of tablets from other brands.

You can obtain cleaning tablets from KRUPS Service Centres.

Scale removal program - total duration: about 20 minutes

The quantity of scale deposited depends on the hardness of the water used. The appliance will automatically warn you

by the ‘CALC’ light coming on when you need to proceed with scale removal.

This program is only accessible when the appliance requests it.

To benet from the guarantee conditions, it is essential to perform the appliance’s scale removal cycle

when informed to do so. Be sure to follow the procedure closely step by step. You can continue to use the appli-

ance when the light is on, but you are advised to perform the program as soon as possible.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Krups EA8161 Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info