Bedienungsanleitung Krups EA83 serie (Seite 26 von 194) (Alle Sprachen)

690032

Zoom out

Zoom in

Vorherige Seite

1/194

Nächste Seite

For drinks with frothy milk or hot water, the drip tray has been specially designed to allow you to fit a large

cup under the steam nozzle or the super cappuccino accessory, once the magnetised box has been

removed. The cup is ideally positioned to collect the frothy milk or the hot water produced by the nozzle

or the super cappuccino accessory. Furthermore, you can use the box as storage for the super cappuccino

accessory.

5.1 Making drinks with hot water

Make sure that the steam nozzle is securely fitted on its tip.

While the screen displays the drink selection menu, press the “hot water” key . Fig. 14.

A message will invite you to place a container under the steam nozzle. Again press the “hot water” key

to produce hot water.

To interrupt the steam function, just press any key.

If the nozzle is blocked, clean it out with a fine needle.

Steam froths up the milk to make a cappuccino or a caffe latte, for example, and also heats up

liquids. As you need a higher temperature to produce steam than to make an espresso, the

appliance runs an additional pre-heating phase for steam.

While the screen displays the drink selection menu, press the “steam” key . Fig. 15.

A screen will inform you that the appliance is being pre-heated. Once the pre-heating phase has been

completed, a message will ask you to place a container under the steam nozzle. Press the “steam” key

again to start generating steam. A little water will be produced first and then steam will start. Use the same

key to stop steam generation.

Be careful, because the cycle does not stop immediately.

Note: We recommend that you use very cold, fresh pasteurised or UHT milk that has been recently

opened. Do not use untreated milk.

6.1 Super Cappuccino Accessory (depending on model)

The super cappuccino accessory helps the preparation of a cappuccino or latte.

Attach the various parts together. Fig. 16

Put the beveled end to the milk.

Select the cappuccino or caffe latte position on the special nozzle. Fig. 17

Fill up the milk pot and place a cup or a glass underneath the Super-cappuccino nozzle.

Fig. 18-19

Press the button to start and then to stop the cycle.

Place your cup under the coffee outlets and start a coffee / espresso cycle. Fig. 20

Important: The inlet must not be twisted.

Cleaning and maintenance: remove the accessory and clean the parts using a small brush and, if necessary,

a little washing-up liquid. Make sure to carefully clean the parts circled in the photo. The hole in the metal

part should not be allowed to become blocked. Fig. 21.

To prevent milk from drying on the auto-cappuccino accessory, it must be cleaned thoroughly after use..

It is recommend that you wash it immediately by carrying out a cycle with steam and the accessory pot

filled with water in order to clean the inside of the nozzle. To do so, you can also use liquid cleaner, available

as an accessory.

5. PREPARING OTHER DRINKS

6. MAKING DRINKS WITH THE SUPER CAPPUCCINO

ACCESSORY OR THE STEAM NOZZLE (depending on model)

KR_ESPRESSO_EA83_EO_EA83_NEW CHARTE 30/05/13 11:35 Page28

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Krups EA83 serie Seite 26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info