Bedienungsanleitung Krups EA8321 (Seite 19 von 20) (Englisch)

565309

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

ENDE

NLESPTITELDANOSVFI

ENGLISH

The milk froth is not fine enough. We recommend that you use fresh, pasteurised or UHT milk,

recently opened; it is also recommended that you use a cold

container. Check that the level of milk in the cold container is

sufficient.

Check that the steam spout is securely tightened onto the hose.

Clean the steam nozzle (refer to chapter 6.1 milk foam).

The Auto-Cappuccino accessory

does not suck the milk (accessory

sold separately).

Some parts of your appliance can sometimes be hot, take care

not to burn yourself; let the machine cool down before handling.

Check that the flexible inlet is not blocked, obstructed or twisted

and that it is securely fitted into the accessory to avoid any air

intake.

Check that the accessory is correctly fitted to the appliance,

remove and refit it.

Make sure that the accessory is set in the right position, either

cappuccino or latte. Remove and clean the accessory (refer to

chapter 6.2 auto cappuccino).

Clean the accessory with a steam cycle and a container filled with

water. You can use the KRUPS XS4000 liquid cleaner available as

an accessory.

If the problem persists replace the part (see photo in chapter 6.2

auto cappuccino, part circled) with the replacement one supplied

with your machine.

After filling the water tank, the

warning message is still displayed.

Check that the tank is fitted correctly onto the coffee

machine.

Check that the float at the bottom of the tank moves freely.

Rinse the tank and descale if necessary.

The cleaning or descaling pro-

gramme will not start.

Unplug the appliance for 20 seconds then switch it back on.

After emptying the used coffee

collector, the warning message is still

displayed.

Remove the collector, ensure that it is empty, wait for 6 seconds

and fit it back in place.

Check that the collector is pushed in correctly.

After washing the cleaning drawer,

the warning message is still

displayed.

Remove the drawer, wait for 6 seconds and fit it back in place.

Check that the cleaning drawer is pushed in correctly.

The power has been cut off during a

cycle.

The appliance resets itself automatically when the power is swit-

ched back on and is ready for a new cycle.

There is water or coffee under or at

the back of the appliance.

Before removing the tank, wait 15 seconds after the coffee has

finished running so that the machine can complete its cycle

correctly.

The drip tray has overflowed: empty it and clean the cleaning

drawer.

Check that the drip tray is properly positioned, even when the ap-

pliance is not in use.

A message “Error code XX”

appears.

Unplug the appliance for 20 seconds, remove the Claris cartridge

and if required, put it back into service.

If the fault persists, note the fault number and contact

KRUPS Customer Service.

When you turn off the appliance,

warm water will come out of the

coffee exits.

According to the type of recipe prepared, the machine can carry

out an automatic rinsing operation when it is turned off. This cycle

lasts only a few seconds and stops automatically.

Always ensure the drip tray is correctly fitted in place.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Krups EA8321 Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Krups EA8321

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info