Replace the water tank.
The ‘water tank’ light
will go off.
1 – Scale removal cycle
The ‘calc’ light will become steady.
The scale removal cycle will have started and will be run
automatically. The pump will suck up water intermittently to be
expelled by the coffee nozzles and then the steam nozzle. This
operation lasts about 10 minutes. Once finished, the ‘water tank’
and ‘calc’ lights will flash.
10
SCALE REMOVAL PROGRAM – TOTAL DURATION: ABOUT 22 MINUTES.
The quantity of scale deposited depends on the hardness of the water used. The appliance will automatically
warn you by the ‘calc’ light coming on when you need to proceed with scale removal.
Caution! To benefit from the warranty conditions, it is essential to perform the appliance scale removal
cycle when informed to do so. Be sure to follow the procedure closely step by step.
You can continue to use the appliance when the light is on, but you are advised to perform the program as soon
as possible.
Press the ‘Service’
key to start up the
scale removal
program. The ‘calc’
and ‘fill water tank’
lights will flash.
Place a receptacle with
a minimum water
capacity of 0.6 l under
the coffee outlets and
under the steam nozzle.
Remove and clean the
drip tray.
Empty the tank and fill
it with lukewarm water
up to the ‘calc’ marking.
Dissolve a sachet of
Krups scale remover
F054 (40 g).
Once you have
performed all these
operations, press the
‘Service’ key.
Only use KRUPS scale removal products, citric acid or tartaric acid. You can obtain scale remover from KRUPS
Service Centres. In no event must you use conventional starchy sulphonic acid or other products containing that acid.
The manufacturer may not be held responsible for damage to the appliance through use of other products.
Empty your receptacle
full of waste water.
Empty the drip tray and
then put it back again
together with the
receptacle as
previously.
Empty, clean and rinse
the water tank and
then fill it again up to
the “Max. level.
Replace your water
tank. The ‘calc’ light will
flash and the “water
tank’ light will go off.
2 – First rinsing
A first rinsing is needed to eliminate the remaining scale remover.
This cycle is run automatically. It lasts about 6 minutes.
Press the ‘Service’ key.
The ‘calc’ light will
become steady. The
automatic cycle will last
6 minutes.
±± 1100 mmnn
±± 66 mmnn
F054
