Bedienungsanleitung Krups Nespresso 897 (Seite 18 von 50) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch)

480410

Zoom out

Zoom in

Vorherige Seite

1/50

Nächste Seite

Each time you make coffee or steam, the

heating system expands (emitting a whistle)

and the water which escapes then runs into

the drip tray.

• After about 20 cups of coffee, the drip tray

must be emptied and clean. Remove the grid

and clean it too (23).

• Before replacing the tray and grid, make

sure that the plastic part par is correctly

positioned at the back of the drip tray.

The capsule holder can be cleaned as per the

rinsing operatin and under the tap. The

capsule holder can be cleaned in the

dishwasher and must be cleaned at least once

a week.

•Clean the steam nozzle using a damp

sponge after each use.

• If the nozzle is blocked, unscrew the pipe using

a coin and unblock the nozzle with a needle.

• When replacing the pipe, take care that the

rubber seal is correctly positioned (24).

To clean the «cappuccino » accessory :

• Seperate parts A and C from the metal stem

B (25).

• Wash all 3 parts in warm water.

If the small opening at the end of A is

blocked, you can unlock it with a needle.

For more thorough cleaning, the capsule cage

can be removed :

• Unplug the appliance, remove the water

tank and the drip tray.

• Place the machine up-side down (26).

• Unscrew the capsule cage with the special

key, anti-clockwise (27) (28).

• Rinse the capsule cage thoroughly under

running water and clean the two perfora-

tions using the unblocking tool (29).

Be careful when using the unblocking

tool, as careless handling could cause

injury.

• Blow in the direction indicated by the arrow

(from bottom to top) in order to clear the

from any impurity (30).

• Clean the water inlet of the capsule cage

using the special mesh found on the end of

the unblocking tool (delivered with the

machine) (31).

• Clean the two perforations again using the

unblocking tool.

• After cleaning put the capsule cage into

special hexagonal key. Make sure that the

parts A, B and C are assembled as shown in

the diagram (32).

• Screw it down again. Do not tighten too

hard, and do not use the capsule holder for

this purpose (33).

Descaling

To ensure that your appliance is working at its

best and for the best quality coffe, it is

strongly recommended that you regularly

descale your Krups Nespresso System (more or

less frequently, depending on the hardness of

your water, but at least once every six

months).

If you require further details, please contact

your Nespresso Club, which can provide you

with a complete descaling kit. The appliance is

delivered with a special hexagonal key and a

cleaning needle ; these tools can also be

useful when descaling your appliance.

Please note!

You should never, in any circumstance,

use vinegar !

Solutions to some problems

Problem:

The coffee temperature is too low .

Solution:

• Refer to the section “Pre-heating Cups”

• Preheat the empty capsule holder by running

through some hot water before making the

coffee.

Problem:

The pump is making a loud noise.

Solution:

• Make sure there is water in the tank.

ART. 897.PM6.5 18/02/04, 10:1018

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Krups Nespresso 897 Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info