Bedienungsanleitung Krups NOVO PLUS FNC3 (Seite 19 von 86) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

549029

Zoom out

Zoom in

Vorherige Seite

1/86

Nächste Seite

• Put the ESE filter holder in place (7) (8) (9)

by pressing it firmly to the right.

• Once the appliance reaches the correct

temperature, the orange temperature

control light will go out.

•

Then turn the selector to the setting (10).

• When the recommended quantity of coffee

has been reached (35 ml) turn the selector

to the O position.

• Remove the ESE filter holder from the

brewing head and throw away the used

measure.

2. STEAM FUNCTION

The tapping noise which occurs while steam is

being produced comes from the intermittent

regulation of the pump and has no effect on

the proper working of the appliance.

If you wish to make an espresso immediately

after steam, the appliance must first be

allowed to cool down in order to achieve the

correct temperature for preparing an

espresso.

• To do this, place a container below the filter

holder without coffee and position correctly,

then turn the selector to the setting

(10).

• Allow the water to flow through until the

orange indicator light comes on. Then turn

the selector to the

O setting.

After this, you can make another espresso.

Beware: during and after use of the ma-

chine, the metallic parts of the steam nozzle

can become burning hot.

. Using the Krups cappuccino accessory

The cappuccino accessory makes it easy to

produce frothy milk for making a cappuccino.

Please note: the cappuccino accessory must

only be used for producing frothy milk.

• Fit the cappuccino accessory to the end of

the steam nozzle (18).

• Fill the water tank (1) (2) (3) and start the

appliance (5).

• Move the nozzle to the exterior of the

appliance.

• Pour about 100 ml of skimmed milk into a

small, narrow container with a capacity of

about 0.5 litres which will fit under the

steam nozzle. The milk and its container

must be well chilled (so it is not advisable to

run the container under hot water before

frothing the milk).

• Turn the selector to the

setting (19).

Once the appliance reaches the right

temperature, the orange temperature control

light will go out.

• Hold the container under the steam nozzle

equipped with the cappuccino accessory in

such a way that the tip is immersed in the

milk.

• Turn the selector to the

setting (20).

Keep the container straight during this

operation. Do not allow the tip of the

nozzle to touch the bottom of the container

because this could obstruct the passage of

the steam.

• Once the froth has been produced, turn the

selector to the setting (19) for the

following cleaning operation in order to

prevent the milk from drying on the steam

nozzle:

• remove the container.

• place an empty container under the steam

nozzle.

• select the setting again (20) to remove

the milk residue.

• turn the selector to the O setting.

• clean the steam nozzle and the cappuccino

accessory with a damp cloth.

For more thorough cleaning of the cappuc-

cino accessory, please refer to the paragraph

on maintenance.

. Heating liquids

Heating liquids is done with the steam nozzle

only.

FNC1/2/3.PM6.5 19/01/04, 16:1719

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Krups NOVO PLUS FNC3 Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info