Bedienungsanleitung Krups XP 1530 (Seite 10 von 15) (Englisch)

507883

Zoom out

Zoom in

Vorherige Seite

1/15

Nächste Seite

ESPRESSO

Making espresso

1.Place your appliance near an electrical outlet

and release enough cord so that you can

plug in the machine (2).

2.Place the filter basket (e8) into the filter

holder (e9) and rotate basket inside filter

holder to secure it (11).

3.Fill with ground espresso. The filter basket is

marked on the inside for 2 and 4 cups. Pack

the coffee lightly and clear any excess coffee

from the rim of the filter holder. This will

assure proper fit to the brewing head

(12).

ATTENTION !

Do not pack coffee too tightly.

Do not fill more coffee than indicated by

the four-cup marking into the filter

basket. This might cause clogging or

overflow.

4.To insert the filter holder, place the filter

handle’s to the left, raise the filter holder up

into brewing head and turn the filter holder

to the right, until it can go no further.

If the filter holder’s handle does not point

toward you in lock position, do not operate

the machine. Rather, remove the filter holder

and reinsert it as described above (13).

By following this procedure this will

prevent the filter holder from being

dislodged as pressure builds up during

the brewing process.

5.Open the hinged lid and unscrew the boiler

cap by turning it counterclockwise

(14+15).

6.Fill the boiler container with cold water

using the marking indicated on the glass

carafe (16).

CAUTION

Never fill the boiler while your appliance

is switched on.

Never fill more than 20 oz of water into

the boiler.

The glass carafe has markings for 2 and 4

cups.

To froth milk for Cappuccino preparation, add

the quantity of water corresponding to the

steam level marking on the carafe.

Maximum capacity to the bottom of the metal

band around the glass carafe = 4 cups of

espresso, plus steam for frothing milk for

cappuccino.

CAUTION

Never fill the carafe above the bottom of

the metal band!

NOTE

It is very important to fill only the amount of

water you need into the boiler. Your appliance

will always need to process all the water

until the boiler is empty.

7.Close the boiler cap securely by turning it

clockwise (17).

8.Place carafe under the filter holder and

make sure the slot on carafe lid is right

below the filter holder output (18).

ATTENTION :

Make sure the overflow grid (e7) is in

place.

9. Make sure the side knob (e2) is set on cup

Espresso position. Then turn the selector

knob (S) to the left in Espresso ON position.

The left indicator will light ON blue (19).

It will take approximately 2 minutes for the

water to be heated. The water will then be

forced through the ground coffee into the

glass carafe.

10. Wait until all the water in the boiler has

been used. Switch off the machine by

turning the selector knob (S) in middle

position.

11. Do not unscrew the boiler cap while

the machine is in operation. Wait until

brewing cycle is completed and all

water and steam have been used (see

CAUTION-PRESSURE).

CAUTION

Use caution when removing the filter

holder, as the metal parts may still be hot.

After switching off the appliance it is

recommended to wait about 2 minutes

before removing the filter holder. To

XP1500/1530 US/F/E.PM6.5 16/03/05, 10:5213

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Krups XP 1530 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info